CipherLab BT 1560 Specification sheet

How to get started with your BT 1560 from Cypher Lab
Your Scanner comes with two parts (a scanner and a cradle) and two cables to
connect the cradle (a) to the computer and (b) to the power.
To connect the power to the cradle
1. Turn the cradle over and look in the bottom of the cradle
2. Now connect the computer cable to your computer and turn the cradle on.
3. Your computer should automatically recognise that this device is connected.
You should see a small message at the bottom of your screen saying “USB
Human Interface Device Installed”
4. When using your barcode for the first time, remember – it is waking up – hold
in the scanner trigger for 3 – 5 seconds until it beeps. Then wait for the
scanner indicator light to show a red bar of light
5. Now, turn over the base unit, there are two small barcodes on the bottom of
the unit
Plug in the power
cable here
Plug the computer
cable in here
Here are the two barcodes you will
need to scan to activate your scanner.

6. Scan the “set connection” barcode first, this is the top barcode
7. Now scan the serial # barcode below it
8. Now on your cradle you should see a rapidly flashing blue light
9. Open a notepad document on your computer and click anywhere within the
notepad document. Scan a barcode from anything you have around you, the
barcode number should appear in the notepad document you just opened.
10. Now the scanner should have a standard flashing blue light.
11. When you put the scanner back into the cradle, the light should turn red, as it
is now charging.