Cisco Linksys E1200 User manual

Linksys E1200 configuration guide
certified router

RingCentral certified router Linksys E1200 | Mac Method
1. Log in to the router. The default IP address is 192.168.1.1.
The default username is “admin”. The default password is “admin”.
2. Click on “Applications & Gaming” tab.
3. Click on “QoS”.
4. Select the radial button “Enabled” next to the field labeled
“Internet Access Priority”.
5. In the field labeled “Upstream Bandwidth”, select “Manual” from
the drop-down menu and enter your current upload speed. (If unsure
of your current upload speed, please run a speed test at http://www.
ringcentral.com/support/capacity.html.)
Configuring QoS on the Linksys E1200
to Prioritize VoIP Traffic (MAC Method)
4
Brand: Linksys
Model: E1200
Hardware Version: E1200
Firmware Version: 2.0.04 build 1
2
3
5
1

RingCentral certified router Linksys E1200 | Mac Method
6. Select “MAC Address” from the drop-down menu
labeled “Category”.
7. You will need the MAC address for each IP device to continue. In the
field labeled “Enter a Name”, enter a unique name for the device for
which you will prioritize traffic.
8. In the field labeled “MAC Address” enter the MAC address for
the device.
6
7
8

RingCentral certified router Linksys E1200 | Mac Method
9. In the field labeled “Priority”, select “High” from the
drop-down menu.
10. Click “Apply” to save changes.
9
10

RingCentral certified router Linksys E1200 | Mac Method
11. Repeat steps 6-10 until you have entered all of the IP phones.
When all have been entered and you see them in the “Summary”
section, click on “Save Settings”.
12. Power cycle/reboot the router before proceeding.
11

RingCentral certified router Linksys E1200 | Port Method
1. Log in to the router. The default IP address is 192.168.1.1.
The default username is “admin”. The default password is “admin”.
2. Click on “Applications & Gaming” tab.
3. Click on “QoS”.
4. Select the radial button “Enabled” next to the field labeled
“Internet Access Priority”.
5. In the field labeled “Upstream Bandwidth”, select “Manual” from
the drop-down menu and enter your current upload speed. (If unsure
of your current upload speed, please run a speed test at http://www.
ringcentral.com/support/capacity.html.)
Configuring QoS on the Linksys E1200
to Prioritize VoIP Traffic (Port Method)
4
2
3
5
1

RingCentral certified router Linksys E1200 | Port Method
6. In the “Category” section, select “Applications” from the
drop-down menu.
7. In the field labeled “Applications”, select “Add a New Application”
from the drop-down menu.
8. Enter a unique name in the “Enter a Name” field. Enter the following
port ranges and select “UDP” from the drop-down menu to the
right of each port range field and set the priority to “High” on the
drop-down menu: 5060-5090, 8000-8200, 16384-16482.
6
7
8a
8b
8c

RingCentral certified router Linksys E1200 | Port Method
9. Click “Apply”. You will see your changes in the “Summary” section.
10. Click “Save Settings”.
11. Power cycle/reboot the router before proceeding.
9
10