Cisco NCS 500 Series Original instructions

Regulatory Compliance and Safety InformationCisco NCS 500 Series
Routers
Information sur la réglementation de la conformité et de
sécuritéCisco NCS 500 Series Routers
First Published: December 19, 2017
Première publication: 19 Décembre 2017
Last Updated: April 13, 2018
Dernière mise à jour: 13 Avril 2018
Cisco Systems, Inc.
www.cisco.com
Cisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the
Cisco website at www.cisco.com/go/offices.
Cisco possède plus de 200 bureaux dans le monde entier. Adresses, numéros de téléphone et numéros de fax
sont répertoriés sur le site Web de Cisco à l' www.cisco.com/go/offices.
RCSI Part Number: RCSI-0349 Rev. 2
RCSI Numéro de pièce : RCSI-0349 Rev. 2

CONTENTS
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers 1
Gesetzliche Auflagen und SicherheitshinweiseCisco NCS 500 Series Routers 17
Cumplimiento de las normas e información de seguridadCisco NCS 500 Series Routers 29
Säädösten noudattaminen ja turvallisuustiedotCisco NCS 500 Series Routers 41
Informations relatives à la conformité et à la sécuritéCisco NCS 500 Series Routers 53
A szabályozásnak való megfelelésre és a biztonságra vonatkozó információkCisco NCS 500 Series
Routers 65
Informazioni sulla conformità alle normative e sulla sicurezzaCisco NCS 500 Series Routers 77
󲼅󴮿󱑦󵨶󱶸󰇎󰈌󰇷󱶹󱎘󲉗󲋵󱩡Cisco NCS 500 Series Routers 89
Informasjon om forskriftsmessig samsvar og sikkerhetCisco NCS 500 Series Routers 101
Regelnaleving en veiligheidsinformatieCisco NCS 500 Series Routers 113
Regulamentação de Conformidade e Informações de SegurançaCisco NCS 500 Series Routers 125
Cisco NCS 500 Series
Routers 137
Information om överensstämmelse med regelverk och säkerhetskravCisco NCS 500 Series
Routers 149
󱘸󴯴󲉗󱚼󱶹󱎘󱈑󲊟Cisco NCS 500 Series Routers 161
Informace o bezpenosti a dodrování pedpisCisco NCS 500 Series Routers 171
      Cisco NCS 500 Series
Routers 177
Cisco NCS 500 Series Routers     183
󸜲󺅫 󺉖󹭮 󹕥 󹺞󺅚󺅫󹙊Cisco NCS 500 Series Routers 189
Informacje o zgodnoci i bezpieczestwieCisco NCS 500 Series Routers 195
Conformidade regulamentar e informações de segurançaCisco NCS 500 Series Routers 201
Dodriavanie predpisov a bezpenostné informácieCisco NCS 500 Series Routers 207
Informacije o skladnosti s predpisi in varnostiCisco NCS 500 Series Routers 213
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
iii

󲼅󴮿󵊥󲇚󴐷󱶹󱎘󴻷󴰺Cisco NCS 500 Series Routers 217
Cisco NCS 500 Series Routers󰥗󰥵󰥘󰤫󰤙󰥠 󰥳󰥥󰥵󰥉󰥩󰤙󰥠 󰤏󰥤󰥯󰥡󰥍󰥤 󰤕󰥤󰥽󰤵󰥠 223
Overholdelse af lovgivningen og sikkerhedsoplysningerCisco NCS 500 Series Routers 229
Usklaenost sa propisima i informacije o sigurnostiCisco NCS 500 Series Routers 235
    Cisco NCS 500 Series Routers 241
       Cisco NCS 500
Series Routers 247
Eeskirjade järgimine ja ohutusteaveCisco NCS 500 Series Routers 249
Reglamentinei atitikties ir saugos informacijaiCisco NCS 500 Series Routers 251
Atbilstba normatviem un informcija par drobuCisco NCS 500 Series Routers 253
Informaii referitoare la siguran i conformitatea cu reglementrileCisco NCS 500 Series
Routers 255
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
iv
Contents

CHAPTER 1
Regulatory Compliance and Safety
InformationCisco NCS 500 Series Routers
Statement 4Power Supply Warning, page 3
Statement 12Power Supply Disconnection Warning, page 4
Statement 43Jewelry Removal Warning, page 4
Statement 94Wrist Strap Warning, page 4
Statement 191VCCI Class A Warning for Japan, page 4
Statement 263Fan Warning, page 4
Statement 289Power Supply Installation Warning, page 5
Statement 294Class A Warning for Korea, page 5
Statement 328Main Ground Connection Warning, page 5
Statement 342Before Connecting to System Power Supply, page 5
Statement 371Power Cable and AC Adapter, page 5
Statement 383Grounding Requirement, Green and Yellow 6 AWG Ground Wire, page 6
Statement 390Power Cord Installed to Power Module, page 6
Statement 1004Installation Instructions, page 6
Statement 1006Chassis Warning for Rack-Mounting and Servicing, page 6
Statement 1007TN and IT Power Systems, page 7
Statement 1008Class 1 Laser Product, page 7
Statement 1011Staring into Laser Beam, page 7
Statement 1015Battery Handling, page 7
Statement 1016Invisible Laser Radiation, page 7
Statement 1017Restricted Area, page 7
Statement 1019Main Disconnecting Device, page 8
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
1

Statement 1024Ground Conductor, page 8
Statement 1026WAN Port Static Shock, page 8
Statement 1028More Than One Power Supply, page 8
Statement 1029Blank Faceplates and Cover Panels, page 8
Statement 1030Equipment Installation, page 9
Statement 1034Backplane Voltage, page 9
Statement 1040Product Disposal, page 9
Statement 1045Short-Circuit Protection, page 9
Statement 1046Installing or Replacing the Unit, page 9
Statement 1047Overheating Prevention, page 9
Statement 1049Rack Installation, page 10
Statement 1053Class 1M Laser Radiation, page 10
Statement 1054Laser Viewing, page 10
Statement 1055Class I and Class 1M Laser, page 10
Statement 1056Unterminated Fiber Cable, page 10
Statement 1058Power and Relay Connector, page 11
Statement 1064Grounded Equipment, page 11
Statement 1071Warning Definition, page 11
Statement 1074Comply with Local and National Electrical Codes, page 12
Statement 1076Clearance Around the Ventilation Openings, page 12
Statement 1080Console Cable with Power Applied to the Unit, page 12
Statement 1088Avoid Servicing Outdoor Connections During an Electrical Storm, page 12
Statement 2007EMC Environmental Conditions for Products Installed in the European Union, page
13
Statement 2017Class A Notice for FCC, page 13
Statement 2021Class A Notice for Canada, page 13
Statement 6005California Perchlorate Contamination Prevention Act (Title 22, California Code of
Regulations, Chapter 33), page 14
Statement 7001ESD Mitigation, page 14
Statement 7002Intra-Building Lightning Surge (For Shielded Cables), page 14
Statement 7003Telcordia GR-1089 NEBS Standard for Electromagnetic Compatibility and Safety,
page 14
Statement 7004Special Accessories, page 15
Statement 7005Intrabuilding Lightning Surge and AC Power Fault, page 15
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
2
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers

Statement 7012Equipment Interfacing with AC Power Ports, page 15
Statement 7013Equipment Bonding Networks CBN, page 15
Statement 7016Battery Return Conductor, page 15
Statement 7017Minimum Steady State DC Input Voltage, page 16
Statement 8012CE MARK with Name and Address of EU Authorized Representative, page 16
Statement 8015Installation Location Network Telecommunications Facilities, page 16
Statement 8016Installation Location Where the NEC Applies, page 16
This document uses the following conventions:
Means reader be careful. In this situation, you might perform an action that could result in equipment damage
or loss of data.
Note
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in
the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Statements using this symbol are provided for additional information and to comply with regulatory and customer
requirements.
Warning
Statement 4Power Supply Warning
Do not touch the power supply when the power cord is connected. For systems with a power switch, line voltages
are present within the power supply even when the power switch is off and the power cord is connected. For
systems without a power switch, line voltages are present within the power supply when the power cord is
connected.
Warning
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
3
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers

Statement 12Power Supply Disconnection Warning
Before working on a chassis or working near power supplies, unplug the power cord on AC units; disconnect the
power at the circuit breaker on DC units.
Warning
Statement 43Jewelry Removal Warning
Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and
watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld
the metal object to the terminals.
Warning
Statement 94Wrist Strap Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the
backplane with your hand or any metal tool, or you could shock yourself.
Warning
Statement 191VCCI Class A Warning for Japan
This is a Class A product based on the standard of the VCCI Council. If this equipment is used in a domestic
environment, radio interference may occur, in which case, the user may be required to take corrective actions.
Warning
Statement 263Fan Warning
The fans might still be turning when you remove the fan assembly from the chassis. Keep fingers, screwdrivers,
and other objects away from the openings in the fan assembly's housing.
Warning
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
4
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers

Statement 289Power Supply Installation Warning
Power supply captive installation screws must be tight to ensure protective grounding continuity.
Warning
Statement 294Class A Warning for Korea
This is a Class A Device and is registered for EMC requirements for industrial use. The seller or buyer should be
aware of this. If this type was sold or purchased by mistake, it should be replaced with a residential-use type.
Warning
Statement 328Main Ground Connection Warning
For Nordic countries (Norway, Finland, Sweden and Denmark) this system must be installed in a Restricted Access
Location, where the voltage of the main ground connection of all equipment is the same (equipotential earth) and
the system is connected to a grounded electrical outlet.
Warning
Statement 342Before Connecting to System Power Supply
High leakage current earth connection essential before connecting to system power supply.
Warning
Statement 371Power Cable and AC Adapter
When installing the product, please use the provided or designated connection cables/power cables/AC
adaptors/batteries. Using any other cables/adaptors could cause a malfunction or a fire. Electrical Appliance and
Material Safety Law prohibits the use of UL-certified cables (that have the "UL" or "CSA" shown on the cord), not
regulated with the subject law by showing "PSE" on the cord, for any other electrical devices than products
designated by CISCO.
Warning
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
5
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers

Statement 383Grounding Requirement, Green and Yellow 6
AWG Ground Wire
This equipment needs to be grounded. Use a green and yellow 6 AWG ground wire to connect the host to earth
ground during normal use.
Warning
Statement 390Power Cord Installed to Power Module
To reduce the risk of electric shock, switch on the power only after the power cord is completely installed into
the power module.
Warning
Statement 1004Installation Instructions
Read the installation instructions before using, installing or connecting the system to the power source.
Warning
Statement 1006Chassis Warning for Rack-Mounting and
Servicing
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure
that the system remains stable. The following guidelines are provided to ensure your safety:
Warning
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit
in the rack.
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers
6
Regulatory Compliance and Safety InformationCisco NCS 500 Series Routers