Cisco PDS2000 User manual

IMPORTANT SAFETY INSTRUCTIONS
20080814_Installer820
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when
unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as a power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
Power Source Warning
A label on this product indicates the correct power source for this
product. Operate this product only from an electrical outlet with
the voltage and frequency indicated on the product label. If you are
uncertain of the type of power supply to your home or business, consult
your service provider or your local power company.
The AC inlet on the unit must remain accessible and operable at all times.
Ground the Product
WARNING: Avoid electric shock and re hazard! If this
product connects to coaxial cable wiring, be sure the cable
system is grounded (earthed). Grounding provides some
protection against voltage surges and built-up static charges.
WARNING: Avoid electric shock and re hazard! Do not
locate an outside antenna system in the vicinity of overhead
power lines or power circuits. Touching power lines or circuits
might be fatal.
Notice to Installers
The servicing instructions in this notice are for use by qualied service
personnel only. To reduce the risk of electric shock, do not perform any
servicing other than that contained in the operating instructions, unless
you are qualied to do so.
Note to System Installer
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
For this apparatus, the coaxial cable shield/screen shall be
grounded as close as practical to the point of entry of the cable
into the building.For products sold in the US and Canada, this
reminder is provided to call the system installer's attention to
Article 820-93 and Article 820-100 of the NEC (or Canadian
Electrical Code Part 1), which provides guidelines for proper
grounding of the coaxial cable shield.
This symbol is intended to alert you that uninsulated voltage
within this product may have sufficient magnitude to cause
electric shock.Therefore, it is dangerous to make any kind of
contact with any inside part of this product.
Ce symbole a pour but d’alerter toute personne qu’un contact
avec une pièce interne de ce produit, sous tension et non isolée,
pourrait être suffisant pour provoquer un choc électrique. Il est
donc dangereux d’être en contact avec toute pièce interne de
ce produit.
Thissymbolisintendedtoalertyouofthepresenceofimportant
operating and maintenance (servicing) instructions in the literature
accompanying this product.
Cesymbolea pourbutde vousavertirqu’une documentation
importante sur le fonctionnement et l’entretien accompagne ce produit.
CAUTION: To reduce the risk of electric shock, do not remove cover (or
back). No user-serviceable parts inside. Refer servicing to qualified
service personnel.
This product may contain a tuner capable of receiving o-the-air
broadcasts.
Protect the Product from Lightning
In addition to disconnecting the AC power from the wall outlet,
disconnect the signal inputs.
Verify the Power Source from the On/O Power Light
When the on/o power light is not illuminated, the apparatus may still
be connected to the power source. The light may go out when the
apparatus is turned o, regardless of whether it is still plugged into an
AC power source.
Eliminate AC Power/Mains Overloads
WARNING: Avoid electric shock and re hazard! Do not
overload AC power/mains, outlets, extension cords, or integral
convenience receptacles. For products that require battery
power or other power sources to operate them, refer to the
operating instructions for those products.
Handling Disposable Batteries
This product may contain disposable batteries. Heed the following
warning and follow the Battery Safety and Battery Disposal
instructions below.
WARNING: There is danger of explosion if the battery is
mishandled or incorrectly replaced. Replace only with the same
type of battery. Do not disassemble it or attempt to recharge it
outside the system. Do not crush, puncture, dispose of in re,
short the external contacts, or expose to water or other liquids.
Dispose of the battery in accordance with local regulations and
instructions from your service provider.
Battery Safety
• Insert batteries correctly. There may be a risk of explosion if the
batteries are incorrectly inserted.
• Do not attempt to recharge ‘disposable’ or ‘non-reusable’ batteries.
• Please follow instructions provided for charging ‘rechargeable’
batteries.
• Replace batteries with the same or equivalent type that we
recommend.
• Do not expose batteries to excessive heat (such as sunlight or re).
• Do not expose batteries to temperatures above 100°C (212°F).
Battery Disposal
• The batteries may contain substances that could be harmful to the
environment.
• Recycle or dispose of batteries in accordance with the battery
manufacturer’s instructions and local/national disposal and recycling
regulations.
• The batteries may contain perchlorate, a known hazardous
substance, so special handling and disposal of this product might
be necessary. For more information about perchlorate and best
management practices for perchlorate-containing substance, see
www.dtsc.ca.gov/hazardouswaste/perchlorate
Provide Ventilation and Select a Location
•Remove all packaging material before applying power to the product.
•Do not place this apparatus on a bed, sofa, rug, or similar surface.
•Do not place this apparatus on an unstable surface.
•Do not install this apparatus in an enclosure, such as a bookcase or
rack, unless the installation provides proper ventilation.
•Do not place entertainment devices (such as VCRs or DVDs), lamps,
books, vases with liquids, or other objects on top of this product.
•Do not block ventilation openings.
Operating Environment
This product is designed for operation indoors with a temperature range
from 32° to 104° F (0° to 40°C). Each product should have adequate
spacing on all sides so that the cooling air vents on the chassis are not
blocked.

Protect from Exposure to Moisture and Foreign Objects
WARNING: Avoid electric shock and re hazard! Do not
expose this product to dripping or splashing liquids, rain, or
moisture. Objects lled with liquids, such as vases, should not
be placed on this apparatus.
WARNING: Avoid electric shock and re hazard! Unplug
this product before cleaning. Do not use a liquid cleaner or an
aerosol cleaner. Do not use a magnetic/static cleaning device
(dust remover) to clean this product.
WARNING: Avoid electric shock and re hazard! Never
push objects through the openings in this product. Foreign
objects can cause electrical shorts that can result in electric
shock or re.
Service Warnings
WARNING: Avoid electric shock! Do not open the cover
of this product. Opening or removing the cover may expose
you to dangerous voltages. If you open the cover, your warranty
will be void. This product contains no user-serviceable parts.
Check Product Safety
Upon completion of any service or repairs to this product, the service
technician must perform safety checks to determine that this product is
in proper operating condition.
Protect the Product When Moving It
Always disconnect the power source when moving the apparatus or
connecting or disconnecting cables.
20110316_Cable_Safety
Cisco PDS2000 Set-Top
Model: PDS2000
Manufactured by: Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134 USA
www.cisco.com/go/contacts
Notice to Consumers
The Cisco® PDS2000 Set-Top receives digital signals from your
service provider and delivers programs in standard denition (SD) and
high denition (HD) formats (720p and 1080i).
You must have an HDTV to display HD programming. Programming
must originate in HD format and be broadcast in HD format.
Please read the safety instructions before connecting your set-top.
Connecting to an SDTV with RCA Cable
Connecting to an HDTV with HDMI Cable
Open Source License Statement
PDS2000 set-tops contain(s), in part, certain free and/or open source
software (“Open Source”) under separate license terms. Examples
of such licenses may include all versions of the GNU General Public
License (GPL), GNU Lesser General Public License (LGPL), BSD
license, MIT license, Mozilla Public License, Eclipse Public License,
Apache license, and others. To nd specic information regarding the
Open Source in your product, including copies of the applicable license
documentation and related information, please go to: (i) for North
America http://www.cisco.com/web/consumer/support/open_source.
html, or (ii) for outside North America http://www.cisco.com/web/
consumer/support/open_source.html#~international. Once at the site,
search for the product listing and click on the related items identied. If
you have any questions or problems accessing any of the links, please
contact: [e-mail].
Cable Input
Back of Set-Top
CABLE IN USB HDMI CVBS/L/R S/PDIF ETHERNET 12V/1ARF IN
Back of
HDTV
ANT (75 )
INOUT
ANT-1
HD 2
Y
OUT
ANT-2
PB
PR
L
R
VIDEO
L/
MONO
R
L/
MONO
R
AUDIO
IN
S-VIDEO
VIDEO
AUDIO
SCART VIDEO OUT
SCART VIDEO IN
HDMI
IN
AUDIO
IN
AUDIO IN
D
VI
/
HD
CP
L
R
IN
HD 1
Y
PB
PR
L
R
AUDIO
To Wall Jack
T16456
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its aliates in the U.S. and other countries. To view a list
of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective
owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.
The terms HDMI and HDMI High-Denition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of
HDMI Licensing LLC in the United States and other countries.
Rovi is a trademark of Rovi Corporation.
© 2014 Cisco and/or its aliates. All rights reserved. Last updated: May 2014 Part Number 78-100397-01A0
T16455
Back of Set-Top
CABLE IN USB HDMI CVBS/L/R S/PDIF ETHERNET 12V/1ARF IN
Cable Input To Wall Jack
Back of
SDTV RF IN
SCART VIDEO IN
RF OUT
RL
AUDIO
IN
VIDEO
IN
Y
PB
PR
RL
AUDIO
OUT
VIDEO
OUT