7.
To transmit: Depress the Push-to-Talk button on the microphone and speak
into the microphone at a normal voice, holding the microphone 3 to 6 inches
from the mouth. Do not shout or move the microphone too close to your
mouth.
8.
To receive: simply release the Push-to-Talk button.
9.
If necessary adjust the Clarifier and RF gain controls for clearer reception.
B.
SSB Reception
1.
Turn the power on and rotate the VOLUME control to a proper sound level.
2.
Temporarily place the LSB-USB-AM switch in the AM position. If the signal
you received is a AM signal, clear voice reception will be obtained. But if the
signal produce unintellegible sound, it may be the SSB signal. First place the
LSB-USB-AM switch in the LSB or USB position at which clearer voice recep-
tion is obtained. Then adjust the Clarifier control slowly for clearest voice
reception.
3.
If necessary adjust SQUELCH and NB control as previously stated.
.
SSB Transmit Operation
1.
First select the channel you want.
2.
Place the LSB-USB-AM switch in the LSB or USB position.
NOTE: If you want to communicate with the station transmitting in a mode of LSB,
your transceiver must be set in the same mode (LSB) of operation. This will be
true for USB operation.
To know a station is being transmitted in either mode of operation, temporari-
ly try to receive the station as stated under SSB reception.
3.
To transmit depress the Push-to-Talk button on the microphone and speak at
the microphone as stated in the step 6 under AM operation.
4.
To receive, simply release the Push-to-Talk button.
When using the transceiver as a public address amplifier
1.
Connect a PA speaker (8-16 ohms) to the PA jack on the rear panel.
2.
Place the CB-PA SWITCH in the PA position.
3.
Turn the power on.
4.
Depress the Push-to-Talk button on the microphone and speak at the microphone.
