Clare Controls ClareOne Assembly instructions

© 28MAY20 Clare Controls, LLC. 1 / 2 DOC ID –1963 • Rev 03
ClareOne Siren Installation Sheet
Last modified: 05/28/20
Part Number: CLR-C1-ZWSRN
Introduction
This guide briefly introduces the ClareOne Siren, part number
CLR-C1-ZWSRN.
Figure 1: ClareOne Siren callouts
Important safety information
Please read this and the online guide(s) at
https://www.clarecontrols.com/helpcenter. Failure to follow the
recommendations set forth by Clare Controls may be
dangerous or cause a violation of the law. The manufacturer,
importer, distributor, and/or reseller will not be held responsible
for any loss or damage resulting from not following any
instructions in this guide or in other materials.
WARNING: To prevent possible hearing damage,
test only when wearing appropriate hearing
protection.
The Siren is intended for indoor use in dry locations only. Do
not use in damp, moist, and/or wet locations.
Programming
The following instructions will step you through installing the
ClareOne Siren and connecting it to your ClareOne Z-Wave
network.
To add the siren to the ClareOne Z-Wave network:
1. Plug the siren into the desired power outlet.
Note: Do not plug the siren into a receptacle controlled by
a switch.
2. Use FusionPro or FusionPro Mobile to put your ClareOne
panel into Z-Wave Discovery mode.
Refer to page 40 of the FusionPro User Guide (DOC ID
1918).
3. Press the Action button on the siren.
When the siren successfully joins the ClareOne Z-Wave
network, its LED flashes twice and turns to a solid color for
2 seconds before turning off.
Note: If the LED flash 3 times before turning off, it did not
join the Z-Wave network; remove the siren and then
repeat the above steps.
The ClareOne Siren is now a part of the ClareOne Z-Wave
network.
To test the siren’s speaker system manually: Press and
hold the Action button for 5 seconds.
WARNING: Test only when wearing proper ear protection.
Siren speaker emits tones up to 105dB that can cause hearing
damage.

2 / 2 DOC ID –1963 • Rev 03
Get help and learn more.
Should you encounter any problem with the ClareOne Siren
visit www.clarecontrols.com/helpcenter or contact our support
team at [email protected].
Manufactured for Clare Controls by Aeotec Limited (#704,
Bright Way Tower, 33 Mong Kok Rd, Mong Kok, Hong Kong)
contactable via aeotec.com/contact. The importer and/ or
distributor of this device can both be reached separately with
the company from whom you have purchased this device from
responsible for warranty, technical support, and compliance
related queries.
Disposal guidelines and WEEE.
Clare Controls devices may contain batteries; remove when
not in use. Do not dispose of device as unsorted municipal
waste, use separate collection facilities. Contact your local
government for further information.
Specifications
Compatible panel
ClareOne (CLR-C1-PNL1)
Repeater
Yes
Z-Wave plus
Yes
Max volume
105 dB, reduced in battery powered mode
Input voltage
120V 60Hz, Max: 30mA
Battery type
Built-in Lithium 430mAh
Battery life
3 hours total use
Alarm power
1.7W
Max standby power
0.7W
Operating environment
Temperature
Relative humidity
32 to 113°F (0 to 45°C)
95% noncondensing
Sensor dimensions
3.3 × 2.2 × 1.8 in.
(83.2 × 55.9 × 45.7 mm)
Certifications
FCC: 15.109 Class B 15.231
FCC Notice
The edition of this device made and certified for the US market
and marked as such complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such
modifications could void the user's authority to operate the
equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures: (1) Reorient or relocate the receiving antenna. (2)
Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. (4) Consult the
dealer or an experienced radio/TV technician for help (5)
Ensure this device and its antenna(s) are not be co-located or
operating in conjunction with any other antenna or transmitter.
RF Exposure Statement.
The device has been evaluated to meet FCC/CE general RF
exposure requirement. The device can be used without
restriction
California Proposition 65.
WARNING: This product contains a chemical known to the
State of California to cause birth defects or other reproductive
harm. Use only for intended purposes. Do not use for other
purposes including, but not limited to, the consumption of food
and drinks
Declaration of Conformity.
Aeotec Limited declares that ClareOne Siren is in compliance
with the essential requirements and other relevant provisions
of RED 2014/53/EU, RoHS 2011/65/EU, IEC 62321:2008, EN
50581:2012 and ErP Directive 2009/125/EC, No 1275/'2008
AMENDMENT 801/2013
Warranty information
Clare Controls offers a two (2) year limited warranty on original
Clare Controls components, from the date of shipment from
Clare Controls.
Contact information
Clare Controls, LLC.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
General: 941.328.3991
Fax: [phone]
www.clarecontrols.com
Integrator/Dealer Support: 941.404.1072
[email protected]
Homeowner Support (ClareCare): 941.315.2273 (CARE)
[email protected]