clare CS-WRP-10 User manual

I
N
S
T
A
L
L
G
U
I
D
E
I
The CS-WRP-10 is a battery backed up device that
extends the wireless range of Clare compatible sensors.
Features
• Extends the range of Clare wireless sensors
• Rechargeable Backup Battery
• Cover and Wall Tamper
• 5-Year Warranty
Enroll the repeater itself by placing the panel into
wireless enrollment mode and then tampering the
repeater. Alternatively, the repeater can be enrolled
using the Install Assist App.
Install by mounting the repeater in the desired location
using the mounting screw holes. Then connect the
power supply to the repeater.
Set the repeater protocol by changing both the
panel and sensor selection knobs to position 8 (Connect+).
Note: This repeater is for Connect+ devices only. Other
sensors and protocols are not supported.
Wall mounting
screw holes
Use two #4 or # 6 screws for mounting (not included)
Wall Tamper Screw Hole
(Do not over-tighten screw)
Enable conguration mode by pressing and releasing the “Congure” button. The
repeater will beep and the yellow LED will illuminate to conrm conguration mode is
enabled.
Conguration Mode Tips
• Conguration mode ends automatically when the cover is closed, the
“Congure” button is pressed again, or 30 minutes after the last action.
• Conguration mode is locked out 24 hours after power up. To re-enter
congure mode, the repeater must be power cycled by removing both the
12VDV input power and backup battery for at least 5 seconds.
• When re-entering conguration mode, previously learned sensors are
retained.
Learn Sensors to be repeated by placing the repeater into conguration mode and
tripping the desired sensors.
• When repeating life safety devices, two repeaters MUST BE used in parallel.
• The repeater will beep after learning each new sensor.
• Sensors not learned into the repeater will not be repeated.
Use the panel installation guide to verify proper system setup.
CS-WRP-10
Wireless Range Repeater

Specications
Physical
Housing Dimensions
Weight with Battery
Mounting Screws
8.5 x 1.0 x 1.3 inches (21.6 x 2.5 x 3.3 Cm)
16 ounces (454 g)
#4 or #6 (Not Included)
Environmental
Operating Temperature
Maximum Humidity
32°F to 120°F (0°C to 49°C)
85% non-condensing relative humidity
Power
12VDC Output
Battery Specications
Transmitted Indications
10.2VDC to 13VDC, 150mA Max
6VDC 800mAh NiMH
Low Battery, Cover Tamper, Wall Tamper, Supervision
Certication
RE620 FCC, IC
Specications subject to change without notice
2019-02-1837-01
941.238.3991
www.ClareControls.com
Original document below
https://bit.ly/2GMk72o