Claridge calyx MIX User manual

MIX
Contemporary
Mobile
ASSEMBLY INSTRUCTIONS
WARNING
Risk of injury to installers and users
Read the enre assembly direcons before
beginning assembly.

MIX Unit Assembly
1. Place pre-assembled board on a flat surface clear or
protected from any debris that may scratch the finish of
the board. Make sure boom side (the end with the leg
mounng holes) overhang the surface edge safely.
2. Collect the appropriate mounng hardware for one leg
- 3 mounng screws
3. Place appropriate right/le leg on the boom end
secon with matching pre-drilled holes
4. Thread screw through a mounng hole and ghten with
an Allen wrench
5. Repeat step 4 for remaining holes
6. Repeat steps 2 through 4 for opposite leg
Mount Leg Casters
1. Collect the 4 casters provided
2. Take one caster and thread the mounng bolt into the
pre-tapped receiver socket on the boom of the leg
3. Tighten with a 14 mm wrench
4. Repeat steps 2 and 3 for remaining casters
Oponal Base Shelf
1. Collect the oponal tray
a. 4 bolts (#4120040)
b. 4 lock washers (#4120039)
c. 4 flat washers (#4120038)
2. Place tray in the locaon between unit legs located by
the mounng holes. The tray is keyed to allow only
correct shelf orientaon
3. Place 1 lock washer, then 1 flat washer on an Allen bolt,
slide washers to the head of the bolt (see diagram A)
4. Thread the bolt through the bolt hole on the mounted
tray into the pre-tapped hole in the leg and ghten with
an Allen wrench
5. Repeat Steps 3 and 4 for remaining mounng holes
800-434-4610
calyxbyclaridge.com
MIX Contemporary Mobile