Clarion ProAudio DRX6675z User manual

DRX6675z 4DRX6675z 38 DRX6675z
Use only compact discs bearing the mark.
Do not play heart-shaped, octagonal, or other specially shaped compact discs.
2. PRECAUTIONS
1. When the inside of the car is very cold and
the player is used soon after switching on
the heater moisture may form on the disc or
the optical parts of the player and proper
playback may not be possible. If moisture
forms on the disc, wipe it off with a soft cloth.
If moisture forms on the optical parts of the
player, do not use the player for about one
hour.The condensation will disappear natu-
rally allowing normal operation.
2. Driving on extremely bumpy roads which
cause severe vibration may cause the sound
to skip.
This equipment has been tested and found to
comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference in
a residential installation.
This equipment generates, uses, and can radi-
ate radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to consult the dealer
or an experienced radio/TV technician for help.
3. When the auto antenna cord is connected to
the car auto antenna cord, when the unit is
switched to the radio mode (or theTV mode),
the antenna is extended automatically. If the
car is in a narrow space, the antenna may
strike something, so be careful.
4. This unit uses a precision mechanism. Even
in the event that trouble arises, never open
the case, disassemble the unit, or lubricate
the rotating parts.
CAUTION
USE OF CONTROLS, ADJUSTMENTS, OR
PERFORMANCE OF PROCEDURES OTHER
THANTHOSE SPECIFIED HEREIN,MAY RE-
SULT IN HAZARDOUS RADIATION EXPO-
SURE.
THE COMPACT DISC PLAYER and MINI DISC
PLAYER SHOULD NOT BE ADJUSTED OR
REPAIRED BY ANYONE EXCEPT PROPERLY
QUALIFIED SERVICE PERSONNEL.
CHANGES OR MODIFICATIONS NOT EX-
PRESSLY APPROVED BY THE MANUFAC-
TURER FOR COMPLIANCE COULD VOID
THE USER’S AUTHORITYTO OPERATETHE
EQUIPMENT.
INFORMATION FOR USERS:.
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BYTHE MANU-
FACTURER WILL VOID THE WARRANTY
AND WILL VIOLATE FCC APPROVAL.
Handling Compact Discs
Handling
• New discs may have some roughness around
the edges. If such discs are used, the player
may not work or the sound may skip. Use a
ball-point pen or the like to remove any rough-
ness from the edge of the disc.
Ball-point pen
Roughness
•Never stick labels on the surface of the com-
pact disc or mark the surface with a pencil or
pen.
•Never play a compact disc with any cellophane
tapeorotherglueon it or withpeelingoffmarks.
If you try to play such a compact disc, you may
not be able to get it back out of the CD player
or it may damage the CD player.
•Do not use compact discs that have large
scratches, are misshapen, cracked, etc. Use
of such discs may cause misoperation or dam-
age.
•To remove a compact disc from its storage
case, press down on the center of the case
and lift the disc out, holding it carefully by the
edges.
•Do not use commercially available CD protec-
tion sheets or discs equipped with stabilizers,
etc. These may damage the disc or cause
breakdown of the internal mechanism.
Storage
•Do not expose compact discs to direct sun-
light or any heat source.
•Do not expose compact discs to excess hu-
midity or dust.
•Do not expose compact discs to direct heat
from heaters.
Cleaning
•To remove fingermarks and dust, use a soft
cloth and wipe in a straight line from the cen-
ter of the compact disc to the circumference.
•Do not use any solvents, such as commercially
available cleaners, anti-static spray or thinner
to clean compact discs.
•After using special compact disc cleaner, let
the compact disc dry off well before playing it.
Flip Down Panel
This unit uses a flip-down structure that makes possible large-size displays.
CAUTION
When opening and closing the FLIP DOWN
PANEL, be careful not to catch your fingers.
They could be injured.
1. Always use this unit with the FLIP DOWN
PANEL closed.
2. Do not force operations or use this device ab-
normally when opening or closing the FLIP
DOWN PANEL.
3. Do not use the FLIP DOWN PANEL as a tray
to place objects on when it is open.
4. When closingtheFLIPDOWN PANEL, donot
press OPEN button 1.
5. Strong impacts to the operating or display
section can cause damage or deformation.
6. If the FLIP DOWN PANEL does not open fully,
gently open it with your hand.
Be sure to unfold and read the next page.
Veuillez déplier et vous référer à la page suivante.
Cerciórese de desplegar y de leer la página siguiente.
Inserting the Batteries
1. Turn the remote control unit over, then slide
the rear cover in the direction of the arrow.
2. Insert the AA (UM-3/1.5V)batteriesthatcame
with the remote control unit facing in the di-
rections shown in the figure, then close the
rear cover.
Notes:
Using batteries improperly can cause them to ex-
plode.Take note of the following points:
• When replacing batteries, replace both batteries
with new ones.
• Do not short-circuit, disassemble or heat batteries.
• Do not dispose of batteries into fire or water.
• Dispose of spent batteries properly.
6. REMOTE CONTROL
Remote control unit
Rear side
AA (UM-3/1.5V)
Batteries
Rear cover
Receiver for remote control unit
Signal transmitter
Operating range: 30°in all directions
Bottom View of Source Unit
286-
Clarion Co.,Ltd.
MADE IN
MODEL
12V GROUND
AM 530-1710kHz/FM 87.9-107.9 MHz
SERIAL No.
PE-
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDI-
TIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFER-
ENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTER-
FERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR
SUB-CHAPTER J APPLICABLE AT DATE OF MANUFACTURE.
CLARION CO., LTD.
50 KAMITODA, TODA-SHI, SAITAMA-KEN, JAPAN.
MANUFACTURED:

5DRX6675z 6DRX6675z DRX6675z 7
4. NOMENCLATURE
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 5 (unfold).
Names of Buttons
3. CONTROLS / LES COMMANDES / CONTROLES
Source unit / Appareil pilote / Unidad fuente
Note: Be sure to unfold this page and refer to the front diagrams as you read each chapter.
Remarque: Veuillez déplier cette page et vous référer aux schémas quand vous lisez chaque chapitre.
Nota: Cuando lea los capítulos, despliegue esta página y consulte los diagramas.
5. DCP
The control panel can be detached to prevent theft. When detaching the control panel, store it in the
DCP (DETACHABLE CONTROL PANEL) case to prevent scratches.
We recommend taking the DCP with you when leaving the car.
Attaching the DCP
1. Insert therightsideofthe DCP into thesource
unit.
2. Insert the left side of the DCP into the source
unit.
2.
1.
CAUTION
• The DCP can easily be damaged by shocks.
After removing it, be careful not to drop it
or subject it to strong shocks.
• If the FLIP DOWN PANEL is kept open, the
DCP may drop due to vibration of the car.
This results in damage to the DCP. So close
the FLIP DOWN PANEL or remove the DCP
to store into the case.
• The connector connecting the source unit
and the DCP is an extremely important part.
Be careful not to damage it by pressing on
it with fingernails, screwdrivers, etc.
Note:
• If the DCP is dirty, wipe off the dirt with a soft, dry
cloth only.
Removing the DCP
1. Hold down POWER button 3for 1 second
or longer to turn off the power.
2. Deeply push in OPEN button 1to unlock
the FLIP DOWN PANEL.
∗If the FLIP DOWN PANEL does not open fully,
gently open it with your hand.
3. Pull the DCP toward you and remove it.
DCP
4. Close the HOLD FLAP.
HOLD FLAP
CAUTION
Be sure to close the HOLD FLAP for safety
when removing the DCP.
With the FLIP DOWN PANEL opened / Ouverture du PANNEAU RABATTABLE /
Apertura del PANEL ABATIBLE
Display / Afficheur /Visualizador
1OPEN button
2ENT (enter) button
Play/pause button
3POWER button
FNC (function) button
4TITLE button
ADJ (adjust) button
5SCN (scan) button
PS/AS (preset scan/auto store) button
6RPT (repeat) button
7RDM (random) button
8Z-EHCR (z-enhancer) button
9Preset buttons (1 to 6)
Direct buttons (1 to 6) (7 to 12)
!DISP (display) button
"ISR (instant station recall) button
#BND (band) button
TOP button
$A-M (audio mode) button
LOUD (loudness) button
%SEARCH button
&Rotary knob
(CD insertion slot
)Eject button
Display Items
1Single disc indication
2Disc in indication
3LD (loudness) indication
4A-M (audio mode) indication
5Function mode indication
∗The names of modes being selected, etc. are
displayed.
6MANU (manual) indication
7ST (stereo) indication
8Z-EHCR (z-enhancer) indication
9DISC indication
!Preset channel indication (1 to 6)
Disc number indication (1 to 12)
∗The disc numbers corresponding to the discs
in the CD or MD changer light.
"Long title indication
#Operation status indication
∗The frequency, play time, clock, etc. are dis-
played.
$RDM (random) indication
%RPT (repeat) indication
&SCN (scan) indication
(BAND indication
)DISC TITLE indication
~TRACK indication