
WOOFER
FEATURES
TWEETER
FEATURES
CROSSOVER
FEATURES
•
UV
protected Injection-
molded polypropylene cone
bodies with santoprene
rubber surrounds, specifically
formulated
for
marine duty
• High-efficiency design with
neodymium motor system • Natural woofer roll-off with 2nd
order high-pass filter on tweeter
• Marine-grade, synthetic spider
• Wide mounting flange
design maximizes retrofit
compatibility with standard
6.5-inch marine speakers
• 1-inch
(25
mm) silk
dome
diaphragm with specially
formulated treatment
to
withstand UV and salt-
spray exposure
• Crossovers are integrated into
woofer basket, requiring no
additional mounting provision
• Ferrofluid-cooled and damped
for
improved response
and power handling
• Meets salt-fog and UV exposure
standards (ASTM
B117
/D4329) • Permanent, basket-mounted
design ensures optimal high-
frequency performance with no
loss
of
woofer radiating area
Included
Components
and
Parts:
• Two Marine Coaxial Loudspeakers
• Two White Sport Speaker Grilles
• Two Gunmetal Sport Speaker Grilles
• Two 2nd Order High-Pass Filters
(integrated within woofer baskets)
• Two 0.250-inch Female Crimpable Connectors
• Two 0.187-inch Female Crimpable Connectors
• Twelve
M4
x
30
mm Stainless-Steel Mounting Screws
• MountingTemplate
• Owner's Manual
BEFORE
YOU
BEGIN
INSTALLING
• Check with your local waterway authority
for any regulations regarding the use
of
accent/speaker lighting on yourvessel.
• Turn
off
the
audio system. It is also
advisable
to
disconnect your battery system
whenever performing installation work.
• Before cutting, drilling
or
inserting any screw,
check
clearances on both sides
of
the planned
mounting surface. Also
check
for
any potential
obstacles, such as wiring harnesses, fuel
lines, hydrau
li
c lines, etc.
Check
both sides
of
the vessel before cutting any holes.
• Ifyou are running cables through bulkheads,
drill holes for
the
cable and use a urethane
or
plastic grommet
to
protect
the
wire from
chafing in the hole. Make sure that
the
cables will clear any mechanical devices in
the
boat and secure them with wire ties.
• Wear protective eyewear at all times and a dust
maskand gloves when drilling
or
cutting.
fflCAUTION
I
When installing speakers
in
your vessel, it is
extremely important
to
secure them firmly. This
applies
not
only
to
the speakers themselves,
but
also any structure they are mounted to. If
not
firmly
attached, the speakers can become dangerous
projectiles in a collision. Please review the
mounting information carefully and use the supplied
marine-grade hardware
to
mount this product.
fl
WARNING
I
While
these
speakers
are
designed tobewater
and
spray
resistant,
they
are
notdesigned to be submerged orto
withstand high-pressure water
spray.
Do notinstall on
submersibles,
personal
watercraft or
any
other
vessel
likely
to be underwater at
any
time.
Please
exercise
care
when
washing your boatto
avoid
damaging your
speaker.
Avoid
contact with
harsh
chemicals
orcleaning
agents
to prevent
damage
to
the
speaker's
finish thatwill notbe
covered
under
warranty.
Wash
with mild
soap
and
rinse
with freshwater
only.
fflCAUTION
I
Prolonged exposure
to
sound pressure levels
in
excess
of
100dB can cause permanent hearing
loss. This high-performance speaker can exceed
this level. Please exercise restraint in its operation
in order to preserve your ability
to
enjoy its fidelity.
fl
WARNING
I
It is absolutely vital that your coaxial speaker
system is connected as shown in this manual.
Failure to connect the system as shown will
result in damage
to
your speakers which
is NOT covered under warranty. Do
not
substitute different crossover networks.