Clark Synthesis TACTILE SOUND AQ339 Aquasonic User manual

Installation Guide
AQ339-Underwater Speaker
Installed in a Jandy Face Ring

Underwater Speaker- Jandy www.clarksynthesis.com
AQUASONIC INSTALL- JANDY FACE RING
Carefully place the Jandy face ring (chrome side down) on a non-abrasive surface. Loosen the screws
until the retaining ring can be removed (see Photo #1 below). Remove the speaker from its box and
place the sound lens on the Jandy face ring (#2). Carefully spread the Jandy retaining ring so it can go
around the speaker’s connecting stud (#3). Evenly align the retaining ring on the speaker.
CAUTION: Overspreading the retaining ring may break the ring.
1
Once aligned, tighten the screws in the retaining ring until they are secure (#4). Do not overtighten.
Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using a
wire puller (#5). Leave 10 to 12 ft. of speaker wire in the niche to allow for easier access during future
servicing of the speaker (#6). Place the speaker inside the light niche (#7).
Note: In actual applications, the niche will already be mounted in the wall of the pool.
2
#1 #2
#4
#3
#5 #6
#7

Underwater Speaker- Jandy
www.clarksynthesis.com
AQUASONIC INSTALL- JANDY FACE RING
3While inserting the speaker, carefully set the lock tab located on the bottom of the face ring behind the
receiving plate located on the bottom of the niche (#8). Align the screw/rubber washer on the face ring
with the threaded receiving hole on the niche (#9). Attach the trim ring securely to the niche by gently
tightening the screw (#10). You are now ready to connect the speaker to your audio system.
#8 #9 #10