TRU Audio ULTRASCAPE PRO User manual

User Manual
Box Contents
(1) 10” Underground subwoofer
(4) Satellite speakers (PRO)
(6) Satellite speakers (PRO+)
(4-6) Satellite speaker ground stakes
(16) Silicone filled wire nuts
Description
This system is designed to work well with most
two-channel receivers or amplifiers, and will support up
to six (6) satellite speakers and one (1) subwoofer. Four
satellite speakers and one subwoofer are included with
the PRO system. The system can be expanded by
adding one additional pair of satellite speakers
UltraScape Pro+
Installation Recommendations
The satellite speakers & subwoofer should be placed evenly so the sound will be distributed throughout
your landscape area. For best results, plan the exact locations of each speaker along with the direct burial
wire prior to digging. See diagram #1 on page 2.
TruAudio recommends that the satellite speakers be placed 6–8 feet apart, and no more than 10 feet for
the best listening experience. An example of a landscape audio layout is shown on page 2.
The ideal position for the subwoofer is in the center of the satellite speaker arrangement; bass response
is enhanced if placed next to a wall or solid surface.
PRO
Speaker Wire Recommendations
Always use multi-strand two or four
conductor direct burial wire designed
for speaker connections to the
receiver or amplifier.
Use this chart to select the minimum
wire gauge for the length of the run.
100
150
250
400
600
Maximum Wire
Length (feet)
Recommended
Gauge
18
16
14
12c
10

Sample Ultrascape Pro Landscape Layout.
Diagram 1
Wiring Diagram
The satellite speakers and subwoofer should be connected in two parallel wire runs and buried in a single
trench. The UltraScapePro is designed for speakers to be evenly divided between two wire runs with the
subwoofer connected to both right and left. Below is a recommended connection.
Use only the waterproof wire nuts that came with your
speakers. This will assure that no water will get in the
connection.
The subwoofer has a dual voice coil with two sets of
connections: one for the right channel, and one for the left.
Make sure that the positive (+) is connected to the positive
(+)and the negative (-) is connected to the negative (-).
Continue connecting the speakers independently to the
right and left channels.
Bundle all three of the right channel positive (+) wires from
the first speaker, and wire the remaining speakers together
as noted here. Then, do the same for the left channel,
negative (-) wires. Run the wires to the next speaker and
connect them the same way.
In-Ground Subwoofer
can be mounted
horizontally or vertical
Horizontal Vertical
RIGHT
LEFT

Installation
TruAudio recommends starting by digging a hole for the subwoofer (sizes noted below), which may be
mounted vertically or horizontally. If mounted horizontally, the hole would need to be approximately 15"
wide × 30" long × 17"– 19" deep. If mounted vertically, the hold would need to be approximately 15" wide
× 15" long × 22"– 24" deep. This will leave approximately 6"– 8" of the subwoofer port tube and cap above
the ground after the installation.
You must add 1"– 2" of gravel at the bottom of the hole to facilitate drainage around the base of the unit. If
you add a layer of gravel, dig the hole 1"– 2" deeper to accommodate it.
+ -
+
R+
ORANGE
-
+ -
+ -
GREEN
L+
+ - + -
+ -
3.5mm to RCA Cable
SOURCE
ULTRASCAPE PRO+
EXPANSION SPEAKER
ULTRASCAPE PRO ULTRASCAPE PRO+
EXPANSION SPEAKER
VERTICALHORIZONTAL

It is the policy of TRUAUDIO to continuously incorporate improvements into our products. All specifications are subject to
change without notice. If you have any questions regarding this or any other TRUAUDIO products, please visit
www.TruAudio.com or contact us:
Office: 1-888-858-1555, Monday-Friday 7 am - 6 pm MST.
Email: [email protected]
TruAudio
198 N Old Highway 91
Hurricane, UT 84737 USA
Subwoofer
Underground subwoofer
10” dual voice coil long throw driver
200 watts
60 watts
11Ω+11Ω
45 - 200 Hz (+/-3 dB)
89 dB 1w/1m
2 channel audio signal in
2 channel signal out
Fiberglass reinforced plastic
12.68” x 16.54”
Speaker Type:
Woofer:
Power:
Minimum Power:
Impedance:
Freq Response:
Sensitivity:
Input:
Output:
Enclosure:
Dimensions:
Satellite Speaker
2-way outdoor landscape speaker
4” waterproof cone with rubber surround
0.75” marine grade PEI
75 watts
20 watts
16Ω
80 - 20K Hz (+/-3 dB)
87 dB @ 1w/1m
Aluminum
Diameter: 5”, Length: 7”, Height: 7.7”
Speaker Type:
Woofer:
Tweeter:
Power:
Minimum Power:
Impedance
Freq Response:
Sensitivity:
Grill Type:
Dimensions:
SoundVision Technologies dba TRUAUDIO
OUTDOOR SPEAKERS and SUBWOOFERS PRODUCT WARRANTY
All outdoor speakers and subwoofers have a limited 5 year warranty. The warranty extends only to the original purchaser of the
product and not to any subsequent owner. TRUAUDIO’s obligation under these warranties is limited to repairing or replacing
any component found defective in material or workmanship under normal conditions of use with an equal and/or current product.
These warranties shall not apply to products which have been abused, modified, or disassembled. Products to be repaired or
returned under this warranty must be returned to the factory through an authorized TruAudio dealer with all transportation and
insurance charges prepaid.
Optional Accessory
ULTRAPRO-BASE: Satellite Speaker Surface Mount