6
English
Mounting the IR remote control receiver
1. Remove the backing of the provided double-sided sticking
tape.
2. Stick the IR receiver onto the front of the TV or onto the wall
about 10 cm away from the bottom corner of the TV.
Operation
1. Plug the mains adaptor into the wall socket. An
audible signal will be emitted and the IR receiver
will flash once.
2. Control the angle of the wall mount using the
arrow buttons 2, 3, 6 and 7. When the mount
comes to the limit of its travel in each angle, an
audible signal will be emitted.
3. Adjust the distance of the wall mount from the
wall in and out using buttons 4 and 8. When
the mount has reached the limit of its travel an
audible signal will be emitted.
1
2
3
4
5
6
7
8
9
IN OUT
SAVE MEMO
Note!
• Buttons 2, 3, 6 and 7 must be held in for the mount to work.
• Buttons 4 and 8 only need to be pushed briefly to start the mount moving in/out.
• Bear in mind that the TV might need to extend out a little away from the wall in order for
the maximum swivel or tilt angles to be achieved.
Memory function
The wall mount can be programmed with 2 memorized positions.
• To store position 1: when the mount is in the desired position, hold in button 5 (save) and then press button 2 once.
• To store position 2: when the mount is in the desired position, hold in button 5 (save) and then press button 6 once.
• To move the mount to one of the memorized positions: hold in the memory button 9 and press button 2 once for
position 1 or button 6 for position 2.
Care and maintenance
If the wall mount is overloaded or if a mechanical fault occurs, it will stop and emit two audible signals.
Troubleshooting
If the wall mount cannot be manoeuvred using the remote controller, check the following:
• That the battery in the remote controller is not flat.
• That the remote controller’s IR receiver and wall mount are not damaged in any way.
• That the remote controller is pointed at the IR receiver and that no obstacle is preventing signal reception.
• That the IR receiver’s cable is undamaged and correctly connected.
• That nothing is preventing the mount from moving to its maximum angles.
• That the mains adaptor’s cable is undamaged and correctly connected.
• That the mains adaptor is plugged into a wall socket.
• That there is power at the wall socket.
Disposal
Follow local ordinances when disposing of this product.
If you are unsure how to proceed, contact your local authority.
1. IR diode
2. Swivel to the left/store
position 1
3. Tilt upwards
4. Back towards the wall
5. Save
6. Swivel to the right/store
position 2
7. Tilt downwards
8. Away from the wall
9. Memory
