Classic Exhibits VISIONARY DESIGNS MOD-1538 Manual

© 2016
www.classicexhibits.com
Order #XXXXX -
11A
3
22A
Velcro: For
Header Graphic
Wire Management
Header Graphic
Item
1/1A
2/2A
3
--
Qty.
1/1
1/1
1
1
Description
47.75”h Vertical Extrusion
47.75”h Vertical Extrusion
19.917”w Z45 Horizontal Extrusion
Large Round Base
Steps:
1) Slide verticals [1] & [2] into the square holes in top of base.
2) Connect verticals [1A] & [2A] to installed verticals [1] & [2].
See Q914 Connection detail.
3) Attach horizontal [3] between verticals [1A] & [2A].
4) Install Monitor Mount to verticals.
See Monitor Mount Attachment detail.
5) Attach Header Graphic to Velcro installed on verticals.
Screws
Connector
Piece
Q914 Connector
Silde extrusion over
connector and rest on
lower vertical;
secure with screws.
**To prevent product loss,
Keep all screws attached
to connector piece after
disassembling
Monitor Mount
Attachment
Slide connectors into
groove of extrusion;
tighten setscrew to secure.
Then attach wall plate
to connectors using
supplied bolts.
Setscrew
*
*
*
*
*
*
*Wire Management
Steps:
1) Run cords through plastic
conduit.
2) Attach conduit where
indicated by pinching the
opening and inserting
into the groove.
3) Attach graphics.
PR63 Wire Management
Power Cord
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
MOD-1538 Assembly

© 2016
www.classicexhibits.com
Order #XXXXX -
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information