ClayTech CMS B3A1 User manual

ClayTech-Pumps-Owners-Manual-CMS-A1-20190814

2.2 bar
Switch must complies with AS/NZS 3133

Claytech guarantee the pump for a period of 2 years or 3 years, from the date of purchase,
depending on the model*. Contact 1300 798 022 for details. Claytech guarantee the
AcquaSaver diverter for a period of 3 years, from the date of purchase. The guarantee
covers manufacturer’s defects in material, or workmanship. The guarantee does not cover
malfunctions due to misuse or due to failure to follow instructions in this manual. Any
alterations to the product are to be performed by a Claytech approved service agent. Any
repairs performed by non approved personnel will void the guarantee.
Supply Cord: If the supply cord is damaged, it shall be replaced by the manufacturer or its service
agent or similarly qualied person in order to avoid a hazard.

pump
controller

Warning! Test the mains pressure
BEFORE installing the CMS Water
Management System. CMS is not to be
used if mains pressure goes above
1000KPa. If the pressure is above
500KPa, a pressure reducer must be
installed. We reccommend that a 500KPa
pressure limiting valve be tted to all
installations of the AcquaSaver in
domestic applications. If the static mains
pressure is greater than 350KPa above
the max pump pressure at the AcquaSav-
er, so the pump can completely shut o
mains water. Failure to lift the pressure
limiting the valve will result in the pump
not starting even though there could be
water in the tank available for use.
Remember mains pressure in your area
can change according to current water
demands. Excessive pressure will cause
damage that is not covered by warranty.

Warning! Test the mains pressure
BEFORE installing the CMS Water
Management System. CMS is not to be
used if mains pressure goes above
1000KPa. If the pressure is above
500KPa, a pressure reducer must be
installed. We reccommend that a 500KPa
pressure limiting valve be tted to all
installations of the AcquaSaver in
domestic applications. If the static mains
pressure is greater than 350KPa above
the max pump pressure at the AcquaSav-
er, so the pump can completely shut o
mains water. Failure to lift the pressure
limiting the valve will result in the pump
not starting even though there could be
water in the tank available for use.
Remember mains pressure in your area
can change according to current water
demands. Excessive pressure will cause
damage that is not covered by warranty.