Clayton Power LPS II Series Operator's manual
Manual and safety instructions | English
LPS II Series
Safety instruction
source with high energy density and dangerous materials in a closed metal case.
Especially keep these rules:
• Do not open the Lithium Power Supply.
• Do not discharge a new Lithium Power Supply before it has been fully charged.
• Do not mount the Lithium Power Supply upside down or on its sides.
• Do not put Lithium Power Supplies in serial or parallel.
• Do not place unprotection from the weather.
• Do not let children or animals come in contact with the unit or power connections.
General actions to be taken by the driver if these dangers occur:
• Put a warning signal on the road to warn others.
• Inform others about the danger and direct them to stand away from the wind direction.
on board.
NON SPILLABLE
Safety instruction .................................................................................................................................
Introduction ..........................................................................................................................................
.....................................................................................................................................................
..............................................................................................................................................
Mounting...............................................................................................................................................
..........................................................................................................................................
Transport...............................................................................................................................................
Storage .................................................................................................................................................
..................................................................................................................................................
Disposal.................................................................................................................................................
Installation and initial start...................................................................................................................5
.................................................................................................................5
Safety protections ................................................................................................................................5
Warranty................................................................................................................................................6
..............................................................................................................................................
.......................................................................................................................................
Introduction
Mounting
Power Cable
The transport of Lithium Power Supply must only be handled by trained people in accordance
retailer for further information.
Storage
When storing the LPS II for a longer period the unit must be fully charged before stored away.
Service
Disposal
Installation and initial start
The initial installation includes setting up the LPS II unit for a standard setup. The following
installation diagram on the last page of the safety manual.
Power 12 V
Power 230 V
5
Safety protections
• Lithium battery protected by fuse (not replaceable)
Warranty
operated as described in this manual.
etc.
Obtaining Warranty Service:
• Proof of purchase
• The unit model number
• The unit serial number
unit.
• Please note that the unit contains Lithium batteries and must be shipped as dangerous goods
Copyright
Back
Dept. Technical reference Created by Approved by
Document type Document status
Title DWG No.
Rev. Date of issue Sheet
06/05/2021
1/1
000418 SubAssembly
Mads Lauenborg
5 6
Dept. Technical reference Created by Approved by
Document type Document status
Title DWG No.
Rev. Date of issue Sheet
06/05/2021
1/1
000417 SubAssembly
Mads Lauenborg
6
Other manuals for LPS II Series
2
Table of contents
Other Clayton Power Power Supply manuals
