Repair or Warranty Contact Clayton Associates, Inc. •1650 Oak Street •Lakewood, New Jersey 08701 •P.+1-732-363-2100 F.+1-732-364-6084
www.DustlessMadeSimple.com
Page 7
GETTING STARTED
1. Locking the cart (optional)
• Close all the drawers
• Ensure the drawers all seat into the same detent position
• Slide the lock bar into either lock bar slot on the top work surface
• Feed the lock bar down through all the drawers adjusting the
drawers as needed
• Insert a customer provided padlock through the hole at the
bottom of the lock bar if desired
2. Hose Hangers / Tool Hangers
• Hose Hangers are provided on either side of the Mobile Workcenter
• Loop each vacuum hose from the vacuum onto each hose hangers
• Use the V slot at the top of the Hose Hanger to hold the sander
or other tool attached to the hose when not in use
3. Pegboard
• Arrange the Lock Hooks in the pegboard as desired
• Additional Lock Hooks can be purchased from...
4. Tube Clips (optional)
• Two optional Tube Clips may be provided to hold vacuum cleanup tools
such as a dust brush or crevice tool
• Snap the dust brush or crevice tool into the Tube Clips
