Clear Water CW13 User manual

09/2019 rev.3 AT21551A01
Address
Bathroom Brands
Lake View House
Rennie Drive
Dartford
United Kingdom
DA1 5FU
[email protected]
"Bylaw n.166/2009 - As bylaw enacted we state that some components of this product are imported from extra-Eu countries. Tested, assembled and inspected inside our factory."
Maintenance of the waste
123
1
2
3
4
5
6
7
8
9
10
INSTALLATIONINSTRUCTIONS
CW13
OVERFLOW BATH SMARTWASTE
tool supplied
94°
Ø85
Ø49
Ø66
Ø40
Ø75
3° max
87
5.6
129
80

Installation notes
• Ensure the air vent is installed at the top of the waste outlet as shown below.
• If temperatures fall below 0 C protect from frost.
• Only use potable mains water, and in particular avoid salt water or water containing contaminants
such as sand or grit.
• Any alterations or modifications to the product will void the warranty
• Do not use any cleaning products containing solvents, acid or alkaline corrosive substances.
• Abrasive sponges or metallic scouring pads should not be used as these could damage the
treated surfaces.
• A small amount of water may continue to drain from the waste during the opening and closing
process when the water level is below the 25cm depth.
• Any use which fails to comply with the installation notes will void the manufacturer's warranty and
liability.
NB: Air vent must be positioned as shown
above.
STARTS TO OPEN
FULLY OPEN
FULLY CLOSED
Inlet
max 28 l/min
Outlet
max 30 l/min
+
-
40cm 1 cm
+
-
25cm 1 cm
+
-
25cm 1 cm
94°
Ø85
Ø49
Ø66
Ø40
Ø75
3° max
87
5.6
129
80
IMPORTANT
45°
NB:
make sure the air-vent is
positioned at 45 degrees maximum
At a depth of 25 cm the Smartwaste gradually starts to
open, until the waste fully opens above a depth of 36 cm.
The drain is fully open when the water level is above 36
cm. The Smartwaste will automatically close when the
water level drops below 25cm.