Clearlight PREMIER IS-1 User manual

CLEARLIGHT PREMIER
FAR INFRARED SAUNAS
OWNER’S MANUAL
Superior Quality and Service
Congratulations on your purchase of a Clearlight Infrared Sauna™.
We are condent that you will enjoy the many benets of your sauna for years to come.
Please read this manual before using your Sauna for the rst time.
Please keep this manual for future reference.

Table of Contents
* The information contained in this manual is subject to change without notice.
Installation ----------------------------------------- 04
01 | PREMIER IS-1, IS-2 AND IS-3 ---------------------- 05
02 | PREMIER IS-5 ---------------------------------- 17
03 | PREMIER IS-C ---------------------------------- 29
Enjoying Your Sauna---------------------------------- 41
Using Your Sauna Control Panel ------------------------- 42
Tips for Use ---------------------------------------- 45
Safety Instructions ----------------------------------- 47
Important Safeguards--------------------------------- 49
Warranty ------------------------------------------ 51
Why Detoxify --------------------------------------- 57

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
4
PREMIER IS-1, IS-2 AND IS-3
Installation
Choosing a location
Place your sauna on a dry and level surface for best results. Garage, basement, attic, playroom, bedroom, or garden
house are just a few of the possible locations for your sauna.
Your sauna’s natural cedar or basswood exterior will beautifully compliment any location.
Outside, place the sauna on a deck or concrete pavers, available at your local building supply store, to protect it from
moisture in the ground which can wick up through the wooden feet. Outside installation also requires our optional
canvas cover.
Installation requirements for your sauna are as follows:
1. Your Clearlight® sauna is a self-contained and freestanding unit. It should not be built into any structure without
prior authorization.
2. Please maintain a minimum of 4-inch clearance on all sides of the unit to allow air to circulate while giving
access for the power cord..
Cleaning and maintenance
1. Before using your sauna for the rst time, clean the inside of the sauna with a damp cloth.
Use your favorite furniture polish on the exterior.
2. Place a towel on the floor and bench to absorb any perspiration. Wash these often to maintain a clean and
pleasant environment inside your sauna.
3. Perspiration may darken the wood over time. This can be removed by a light sanding with ne grit sandpaper.
Please be careful when carrying and installing the glass pieces to avoid breakage. Make certain the glass is securely fastened
during installation before letting go of any individual piece that could break.

EU [phone] | Germany [phone] www.clearlight-saunas.eu
5
PREMIER IS-1, IS-2 AND IS-3
PREMIER IS-1,
IS-2 AND IS-3
01
FS Packaging - - - - - - - - - - - - - - - - - - - - - - 06
Assembly Instructions - - - - - - - - - - - - - - - - - 07

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
6
PREMIER IS-1, IS-2 AND IS-3PREMIER IS-1, IS-2 AND IS-3
FS Packaging
Box 1 of 4 Box 2 of 4 Box 3 of 4
1. Floor Panel 1. Left Side Wall 1. Front Wall
2. Ceiling Panel 2. Right Side Wall 2. Back Wall
3. Accessories 3. Bench & Bench Support
4. Install Manual
CONTENTS OF BOXES
ACCESSORY BOX CONTENTS
Door Handle and
Screw Hole Covers
Light Shade
Light Fixture
Wood piece
(2 pieces)

EU [phone] | Germany [phone] www.clearlight-saunas.eu
7
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions
Assembly of the sauna requires two adults to complete. Please read the instructions thoroughly before and during
assembly to ensure proper installation of the unit. If you encounter any problems or have questions during assembly,
please feel free to call our Customer Service department at 1-800-798-1779 or [phone].
When determining a location for your sauna, please keep in mind the following:
1. The main power cord on the sauna must be easily accessible.
2. The location must be dry and level.
3. Panels should be installed in the following order:
1) Floor 4) Right Side Wall 7) Front Wall
2) Back Wall 5) Under Bench Support 8) Roof
3) Left Side Wall 6) Bench
1. Place the bottom floor panel on the ground
near the location you will using the sauna.
Make sure the front of the floor is in the
desired location of the door. The door
magnet indicates the front of the sauna.
1. Place the back panel on the floor panel by lining up the
back panel on the groove of the floor panel.
1 - LOCATION OF SAUNA & INSTALLATION ORDER
2 - PLACING FLOOR PANEL 3 - CONNECTING THE BACK PANEL
TO THE FLOOR PANEL

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
8
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’dAssembly Instructions Cont’d
The side wall panels will be connected to the back wall by connecting together the installed brackets. There are
“+” brackets and “-” brackets on the side of each panel. The side walls will be installed as follows:
1. Place the left side wall in the slot in the floor.
Lift the side wall up about 4” (10cm) higher
than the backwall panel (See Picture 1).
2. Place the side wall panel against the back wall
(See Picture 2), then slide down side wall panel
until the two panels are equal height. (See
Picture 3).
3. If the panels are not equal height or there is
an obvious gap between the two panels, this
means they are not propery attached and you
should try again.
4. Repeat the steps above for the right side wall
panel.
4 - CONNECTING SIDE WALLS
Right Side Wall Installed
Picture 1 Picture 2 Picture 3
Left Side Wall Installed
If the panels still seem too tight to come
down all the way, try backing off the
bracket screws by one half turn with a
Phillips head screwdriver on the female
bracket.

EU [phone] | Germany [phone] www.clearlight-saunas.eu
9
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
Slide down the bench heater panel by lining up its sides with the vertical guides on the left and right side wall
panel.
1. Be careful not to scratch the side panels when positioning the heater panel.
2. Push the bench heater panel all the way down until it is touching the floor panel and is securely in place.
5 - INSTALLING UNDER BENCH SUPPORT
Vertical bench heater
panel guides are found
on the side panels.
Heater must be
facing outward

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
10
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
Follow the connections as in the following illustration:
1. Connect the black and white cable coming out of the back of the under bench support to one of the left side
wall connectors.
2. Connect the side black and white wall cable to one of the floor connectors.
3. Connect the black and white back wall cable to the other floor connector.
4. Connect the green ground connectors together.
5. The two remaining cables labeled “VRT” will be connected if Vibrational Resonance Therapy is being added to
the sauna. If you did not add this to your sauna, these cables will not be used.
6 - CONNECT HEATER CONNECTION UNDER BENCH
You can plug any male connector to a female one as long as the colors match.

EU [phone] | Germany [phone] www.clearlight-saunas.eu
11
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
Install the bench by sliding it over the horizontal bench guides on the side panels. Be careful not to scratch the
adjacent panels when sliding in the bench.
Push the bench all the way in until it touches the back panel and is securely in place.
The bench is reversible. One side is ergonomic and one side is flat. You can reverse the bench after the sauna
installation is nished. Be sure that the bench is pushed all the way back until it slides under the heater guard
to secure the bench in place.
LEFT
TOP
BOTTOM
FRONT
BLACK
LEFT
TOP
BOTTOM
FRONT
BLACK
7 - INSTALLING THE BENCH
Optional: After the bench is installed, you can
slide in the included wood pieces to prevent
the bench from sliding left to right. One piece
can be placed on each side next to the bench.
If you decide to flip the reversible bench over,
please remove the wood pieces rst.

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
12
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
1. Place the front wall in the slot in the floor.
2. Align the brackets in the front wall and make sure they
are locked in place.
8 - INSTALLING THE FRONT WALL

EU [phone] | Germany [phone] www.clearlight-saunas.eu
13
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
1. Lower the roof panel on to the assembled panels.
2. Position the top panel so that the exterior lights are at the front of the sauna.
3. Make sure that the cables from the top panel do not get pinched when placing the panel.
4. Gently place the top panel onto the rest of the assembled panels. When all four corners are in place, gently
push down the roof panel from the outside corners until it ts snugly over the rest of the panels.
9 - INSTALLING THE ROOF PANEL
(7)

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
14
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
10 - CONNECT HEATERS IN ROOF
1. Locate the “trap” doors that open in the roof.
2. Connect the black and white cables that come
out of the walls to the connector located in the
roof.
3. Connect the green ground wire that come out of
the walls to the green ground wire that is in the
roof. Push the wiring inside the roof area and
close the roof door compartments.
4. In the left side wall compartment, there will be
two connectors: 1) Heater connector. 2) Keypad
connector. The heater connector is a two wire
connector. The keypad connector is a seven wire
connector.
BE SURE TO MATCH THE COLORS IN THE CONNECTORS.
THE BLACK WIRE SHOULD MATCH UP WITH THE BLACK WIRE, ETC.
1. Locate the door handle.
2. Attach the door handle using the enclosed bolts.
3. Insert the included decorative mushroom caps
in the screw hole to cover the screws.
11 - INSTALLING DOOR HANDLE
Note: If you are using a tablet or smartphone, the door handle will act as both the door handle and
tablet/smartphone holder when the door is closed.

EU [phone] | Germany [phone] www.clearlight-saunas.eu
15
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
1. Plug in the light xture to the left back wall plug and screw the light xture in place.
2. Place the wooden light shade over the installed light xture. The light shade will attach by the installed
magnets.
12 - INSTALLING THE INSIDE LIGHT FIXTURE AND WOOD LIGHT SHADE
Light Fixture
Light Shade Light Fixture and Light
Shade installed
13 - LOCATING AND PLUGGING IN POWER CORD
The power cord comes out of the roof of the sauna. If you are standing facing the sauna, it comes out of the rear
left corner of the roof. Open the trap door to access the power cord and run the cord down the back of the sauna.
The power cord will plug into the appropriate electrical receptacle.
Note: We do not recommend using an extension cord for your sauna.
Please plug the sauna directly into the wall receptacle.
Light Fixture

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
16
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
Installation of your sauna is now complete. Using a damp cloth, wipe out the sauna to remove any excess
saw dust that may have settled on the wall & floor panels and the heater panels.
Please refer to usage instructions located later on in this manual.
14 - INSTALLATION IS COMPLETE

EU [phone] | Germany [phone] www.clearlight-saunas.eu
17
PREMIER IS-1, IS-2 AND IS-3
PREMIER IS-502
FS Packaging - - - - - - - - - - - - - - - - - - - - - - 18
Assembly Instructions - - - - - - - - - - - - - - - - - 19

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
18
FS Packaging
Box 1 of 4 Box 2 of 4 Box 3 of 4
1. Floor Panel 1. Left Side Wall 1. Front Wall
2. Ceiling Panel 2. Right Side Wall 2. Back Wall
3. Accessories 3. Bench & Bench Support
4. Install Manual
CONTENTS OF BOXES
ACCESSORY BOX CONTENTS
Door Handle and
Screw Hole Covers
Light Shade
Light Fixture
Wood piece
(2 pieces)
PREMIER IS-5

EU [phone] | Germany [phone] www.clearlight-saunas.eu
19
Assembly Instructions
Assembly of the sauna requires two adults to complete. Please read the instructions thoroughly before and during
assembly to ensure proper installation of the unit. If you encounter any problems or have questions during assembly,
please feel free to call our Customer Service department at 1-800-798-1779 or [phone].
When determining a location for your sauna, please keep in mind the following:
1. The main power cord on the sauna must be easily accessible.
2. The location must be dry and level.
3. Panels should be installed in the following order:
1) Floor 4) Right Side Wall 7) Front Wall
2) Back Wall 5) Under Bench Support 8) Roof
3) Left Side Wall 6) Bench
1. Place the bottom floor panel on the ground
near the location you will using the sauna.
Make sure the front of the floor is in the
desired location of the door. The door magnet
indicates the front of the sauna.
1. Place the back panel on the floor panel by lining up the
back panel on the groove of the floor panel.
1 - LOCATION OF SAUNA & INSTALLATION ORDER
2 - PLACING FLOOR PANEL 3 - CONNECTING THE BACK PANEL
TO THE FLOOR PANEL
PREMIER IS-5

EU [phone] | Germany [phone]
www.clearlight-saunas.eu
20
Assembly Instructions Cont’dAssembly Instructions Cont’d
The side wall panels will be connected to the back wall by connecting together the installed brackets. There are
“+” brackets and “-” brackets on the side of each panel. The side walls will be installed as follows:
1. Place the left side wall in the slot in the floor.
Lift the side wall up about 4” (10cm) higher
than the backwall panel (See Picture 1).
2. Place the side wall panel against the back wall
(See Picture 2), then slide down side wall panel
until the two panels are equal height. (See
Picture 3).
3. If the panels are not equal height or there is
an obvious gap between the two panels, this
means they are not propery attached and you
should try again.
4. Repeat the steps above for the right side wall
panel.
4 - CONNECTING SIDE WALLS
Right Side Wall Installed
Picture 1 Picture 2 Picture 3
Left Side Wall Installed
If the panels still seem too tight to come
down all the way, try backing off the
bracket screws by one half turn with a
Phillips head screwdriver on the female
bracket.
PREMIER IS-5