ClimaRad Ventura V1C User manual

User instructions ClimaRad Ventura V1C
2019.001
The ClimaRad Ventura V1C is equipped with sensors for CO , humidity, indoor and outdoor temperature and
2
pressure sensors for balance control. They measure the air quality and automatically determine the required
ventilation for each room. The device also features convectors, allowing the unit to ventilate, heat and
(optionally) cool.
Operating principle ClimaRad Ventura V1C
ClimaRad Ventura V1C
The control panel is situated on the front of the device. You can find the function buttons and notifications of the
panel in question on page 2 of this instruction manual.
The ClimaRad Ventura V1C in your room is optimally configured by the installer and functions fully automatically.
That is why we only explain the function buttons that are relevant for you during daily use.
Operating the ClimaRad Ventura V1C
You can set the desired temperature yourself by turning the ring.
Turn left for lower temperatures, turn right for higher temperatures.
Operating the ClimaRad Round
F u t u r e c o m f o r t t o d a y

Press 4 seconds simultaneously
Press for 6 seconds
Child lock: The child lock is activated.
Error: A fault has occurred. Please contact your installer or
housing corporation.
Dirty filter: Replace the air filters or contact your installer or
housing corporation After replacing the filters, press the + and -
buttons for 6 seconds.
Messages Switch off
ClimaRad B.V. - Lübeckstraat 25 - 7575 EE - Oldenzaal - NL - [e-mail] - www.climarad.co.uk - tel. [phone]
•
Function Keys
Automatic control: The ventilation, heating and cooling system in the
room are automatically controlled by your ClimaRad Ventura, which
functions based on CO2 measurements and temperature.
Pause: Use this function if you want to stop ventilating temporarily.
After a period of 4 hours, your ventilation unit will reset to automatic
control.
Ventilation (manual): This function allows you to activate the
ventilation function of your device. You can then use the + and - on
your control panel to configure the ventilation speed. After a period of
8 hours, your device will reset to automatic control.
Temperature: You can set the desired temperature yourself using the +
and - on your control panel in order to heat up or optionally cool down
the room.
No function.
A U T O
•
A U T O
ClimaRad Ventura V1C
•
F
I
L
T
E
R
M
A
N
U
A
L
S
P
E
E
D
T
E
M
P
•
Child lock: This key combination locks your control panel. Press the
indicated buttons simultaneously for 4 seconds. If you want to unlock
the device, repeat this action.