Climate RENTAL SOLUTIONS POWER BREEZER MACH 4 User manual

MACH 4
POWER BREEZER MISTING FAN
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
USER MANUAL

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 2
TABLE OF CONTENTS.........................................................................................2
WARNINGS............................................................................................................3
KEY COMPONENTS.............................................................................................4
SETUP....................................................................................................................6
MOUNTING THE FAN HEAD................................................................................6
USING THE CORRECT OUTLET ........................................................................9
ADDING WATER TO THE WATER TANK..........................................................10
ROUTING POWER AND WATER LINES AND REPLACING TANK LID .........10
OPERATION ........................................................................................................11
CONTROL PANEL – BUTTONS .........................................................................11
TURNING ON YOUR POWER BREEZER......................................................... 11
ADJUSTING THE MISTING LEVEL...................................................................12
DISASSEMBLY....................................................................................................13
DISMOUNTING FAN HEAD................................................................................14
ROUTING POWER AND WATER LINES AND REPLACING TANK LID .........15
MOVING / TRANSPORTING YOUR POWER BREEZER ................................16
MAINTAINING YOUR POWER BREEZER........................................................16
MAINTAINING THE WATER TANK ....................................................................16
MAINTAINING THE FAN HEAD AND MOTOR..................................................16
TABLE OF CONTENTS

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 3
• This Power Breezer is intended for use only as specied in this manual. If you have questions about its use,
please contact Power Breezer. 844.233.5673 | [e-mail]
• Use only on a outlet protected by a ground-fault circuit-interrupter (GFCI). (see page 10)
• Avoid using extension cords.
• Do not allow plug to become wet. Do not plug in while hands are wet. Doing so causes risk of electric shock.
• Do not alter the plug in any way.
• If the power cord is damaged, do not attempt to repair it yourself. Contact Power Breezer customer service for
assistance. 844.233.5673 | [e-mail]
• Turn o󰀨 and unplug the Power Breezer prior to lling or emptying water reservoir.
• Turn o󰀨 and unplug the Power Breezer prior to moving.
• Turn o󰀨 and unplug the Power Breezer prior to cleaning it.
• Always unplug the Power Breezer by pulling on the plug and never on the cord.
• Do not insert ngers or other objects inside the fan head, doing so may cause bodily injury.
• Children can fall into open water reservoir and drown, even in a small amount of water. Keep children away from
reservoir. Keep the water tank lid on at all times.
• Closely supervise nearby children and pets when using this Power Breezer. Do not leave Power Breezer unat-
tended.
• Children shall not play with the Power Breezer.
• Cleaning and user maintenance shall not be made by children without supervision.
• The Power Breezer is not to be used by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
• This Power Breezer can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or in-
struction concerning use of the Power Breezer in a safe way and understand the hazards involved.
• When operating Power Breezer, use common sense. Stay clear of moving parts and only use water that is safe
for drinking.
• If the Power Breezer becomes damaged or malfunctions, do not attempt to repair the Power Breezer. Doing so
will void the warranty. Contact Power Breezer customer service for repair assistance. 844.233.5673 | custom-
[e-mail]
• The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabil-
ities, or lack of experience and knowledge, unless they have been given supervision or instruction” or equivalent.
• This Power Breezer is suitable for use as a fan for tropical climates.
• This Power Breezer is suitable for use outdoors.
• This Power Breezer is intended for industrial use.
• This Power Breezer is rated IP24.
• Do not throw away this user manual, keep it for reference.
WARNINGS

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 4
KEY COMPONENTS

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 5

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 6
MOUNTING THE FAN HEAD
To set up your Power Breezer, you will need:
• 2 people
• An AC outlet
• Access to water to ll the water tank
Remember:
• Lift fan head only by the head handles.
• Never lift from the fan guards.
• The fan head weighs 86 lbs.
Before you get started, be sure to lock both of the rear
wheels by pressing down on the brake lever to set
them to the ON position.
Open the lid latch by rst pulling forward the lower
portion of the latch.
SETUP

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 7
Finish opening the lid latch by pulling the upper
portion of the latch forward and away from the lid.
Remove tank lid by rst lifting up on the transport
handle and then pulling forward.
Tilt up the four fan head handles, if they are folded
down, prior to lifting the head.
To lift the fan head out of the water tank, each person
should stand on opposite sides of Power Breezer.
Both people should grasp the fan head by the fan
head handles, as shown.
Remember:
• Lift fan head only by the head handles.
• Never lift from the fan guards.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 8
Lift the fan head straight up and out of the water tank.
Carefully rest it on the edge of the water tank.
Both people should re-adjust their grip so that they
have one hand on a fan head handle or the black
outer housing and one hand on the front edge of the
fan head, as shown.
Once again, lift the fan head and align it with the fan
head support pole. Once the fan head is seated on
the support pole, rotate the fan head horizontally
until you feel it engage with the support pole.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 9
Once installed, the atomizer (metal disk) will be facing
the water tank, air will be blown over the water tank
when the Power Breezer is turned on.
USING THE CORRECT OUTLET
Electrical current of 110v or 220v is required. For safety, only plug your Power Breezer into an outlet equipped with
GFCI.
DO NOT plug into standard outlet without a GFCI feature.
GF CI
E
O
NOTE: A live power outlet can be veried when the Power Breezer is plugged in and powered o󰀨 by pressing
the oscillation or atomizer buttons. The LED lights will dimly illuminate when either of these buttons are
depressed.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 10
ADDING WATER TO THE WATER TANK
Do not ll the water tank above the max ll level, as
shown. If water tank is lled past this level, water may
leak out of the water tank and cause a hazard around
the Power Breezer.
The water valve can be adjusted for optimal performance
according to your climate. To adjust, please follow the
steps in the Operation - Adjusting the misting level
section of this manual.
ROUTING POWER AND WATER LINES AND REPLACING TANK LID
• Route the fan head power cord, atomizer drain hose, and water inlet hose through the openings in the back
of the water tank as shown above.
Note the tank lid tab on the back underside of the tank lid.
• Slide the lid tab into the corresponding water tank notch in the back of the water tank as shown above.
• Lower the front of the tank lid onto the water tank and re-lock the lid latch.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 11
CONTROL PANEL – BUTTONS
TURNING ON YOUR POWER BREEZER
1. Press the power button and hold for one second. The LED light for the power button will be lit and the
fan blades will begin to slowly rotate to indicate the Power Breezer is powered on.
2. Press the fan speed button to increase the fan speed. Adjust the fan speed by pressing the or
buttons.
3. Press the oscillation button once to activate the oscillation feature.
4. Press the atomizer button once to activate the misting feature.
OPERATION

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 12
ADJUSTING THE MISTING LEVEL
1. Press the power button and hold for one
second if Power Breezer is not already on.
2. Set fan speed to desired level.
3. Locate the water valve. The water valve is inside
the water tank towards the rear.
4. Start with the water valve closed, at the 6 o’clock
position as shown.
5. Start the atomizer by pressing the atomizer but-
ton once.
• Open the water valve slightly by turning the le-
ver counterclockwise. There will be a short delay
before misting begins. Check the distance of the
mist.
• If there is a strong mist at 6 feet away, then the
moisture setting is too high for conditions. To re-
duce misting, rotate the water valve lever clock-
wise back towards the 6 o’clock position.
Optimal moisture settings can also be adjusted
according to personal preference.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 13
DISASSEMBLY
To disassemble your Power Breezer, you will need:
• 2 people
Remember:
• Lift fan head only by the black outer shell from the
top and bottom.
• Never lift from the fan guards or metal disk.
• The Fan Head weighs 86 lbs.
1. Power o󰀨 the Power Breezer by holding down the
power button for one second.
2. Unplug power cord.
Drain water tank:
Depending on the volume of water to be drained, you
may want to move your Power Breezer to a suitable
location prior to draining.
Open the drain plug by turning counter clockwise and
fully drain the water tank.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 14
DISMOUNTING FAN HEAD
Before you get started, be sure to lock both of the rear
wheels by pressing down on the brake lever to set
them to the ON position.
• Unlock lid latch.
• Remove the tank lid by rst lifting up on the
transport handle and then pulling forward.
Lift the fan head straight up and o󰀨 the head support
pole.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 15
Carefully rest the fan head on the edge of the tank.
Both people should grasp the fan head by the fan
head handles, as shown.
Remember:
• At this step, lift the fan head only by the head
handles.
• Never lift from the fan guards.
Carefully lower the fan head into the water tank.
ROUTING POWER AND WATER LINES AND REPLACING TANK LID
• Route the fan head power cord, atomizer drain hose, and water inlet hose through the openings in the back
of the water tank as shown above.

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 16
Note the lid tab on the back underside of the lid.
• Slide the lid tab into the corresponding water tank notch in the back of the water tank as shown above.
• Lower the front of the lid onto the water tank and re-lock the lid latch.
MOVING / TRANSPORTING YOUR POWER BREEZER
DO NOT reposition or move your Power Breezer by the fan head (if mounted) or the fan head support pole (if
stored). Doing so may damage your Power Breezer. Only reposition or move your Power Breezer by the transport
handle.
Prior to transporting your Power Breezer over long distances, disassemble the Power Breezer to prevent damage.
Use the tie down points to limit movement and prevent damage. Also make sure both rear wheel locks are engaged
in the ON position to prevent rolling.
For long-term storage, make sure that the water tank is fully dry. If it is not dry, you may use the fan to dry it.
• With the fan head in the water tank, and the tank lid removed, turn on the fan using a medium speed until the
water tank is dry.
MAINTAINING YOUR POWER BREEZER
For the best performance and longest life of your Power Breezer, we recommend the following maintenance on your
Power Breezer every 30 days and prior to storing for extended periods of time.
MAINTAINING THE WATER TANK
• The Power Breezer was designed with easy cleaning in mind.
• Once a week drain the water tank and allow for the water tank to dry out overnight.
• If the inside of the water tank becomes slippery/slimy to the touch, drain the Power Breezer. You can also clean
the water tank by putting a few drops of liquid soap in water and brushing the inside of the water tank with it.
Rinse the water tank with a hose, then open the drain plug at the bottom and leave the tank lid o󰀨 to allow to
air dry.
MAINTAINING THE FAN HEAD AND MOTOR

USER MANUAL MACH 4 POWER BREEZER MISTING FAN
Page 17
If you see a collection of dust or debris in the head of the
Power Breezer, clean the Power Breezer with a water
hose.
Spray from the front of the fan head. Use a clean cloth
to wipe it down.
Avoid spraying water directly into the vent.