Fan Filters – electrical connection of the fan filters
The voltage and frequency must be according to the rated values stated on the label.
The electrical connection must be carried out according to the local standards and safety regulations which govern
the use of electrical material.
Electrical connection and repairs must be carried out by qualified personnel.
Replacement and cleaning of the filter media
- To remove the filter, slide the cover on the base by raising the
bottom and pushing it upwards
- Re-insert the cover into the base after cleaning the filter
- The filter can be cleaned by rinsing, spraying or beating
- The frequency with which the filter must be replaced depends
on the amount of dust accumulated, operating period, and
specific working conditions encountered by the user
Note: an unclean filter reduces the efficiency of the fan-filter
casing insufficient or finally a total lack of ventilation.
Dismounting
If the filter or the fan filter cannot be removed from its seat, please follow
the instructions below:
Filter – using fine-nosed pliers, apply light pressure to the clips while pushing
inwards towards the enclosure. This will release the clips from the base.
Fan filter – remove the fan and follow the instructions for the filter
dismounting.
Printed in Canada: 17-10 EM-1750-0
