Climate RENTAL SOLUTIONS AM 100 User manual

INSTRUCTION MANUAL
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Owner’s Manual AIR MOVER

READ AND UNDERSTAND ALL WARNINGS AND
INSTRUCTIONS BEFORE USING THIS AIR MOVER!
VOLTS
POWER
CYCLE
MAX AIR VOLUME
AMPS LOW/MID/HIGH SPEEDS
WEIGHT
SIZE L/W/H
SPEED
CORD LENGTH
240V
1/4HP
50Hz
1100CFM
1.6/1.7AMPS
9.5KGS
55x43.5x23cm
2 SPEEDS
5M

Problem Cause Solution
Unit will not run.
Unit runs but air mover makes
loud scraping noise.
Unit runs but vibrates
excessively.
Unit runs but blower wheel
does not turn.
1. No power to nuit.
2. Switch not on.
3. Switch is faulty.
4. Faulty/broken cord or motor wire
1. Unit has been severely jolted causing blower wheel
to rub against housing.
2. Unit has been severely jolted causing housing to
deform.
1. Severe jolt has bent motor shaft causing unit to be
out of balance.
2. Air mover blade damaged.
3. Dirt build up on one side of air mover blade.
1. Motor bearings are failing or motor has developed
an internal electrical fault.
2. Intake grill and/or exhaust grill is obstructed.
3. Excessive duct length.
1. Plug unit in. Check circuit breaker.
2. Place in “ON” position.
3. Replace switch.
4. Perform continuity check, using volt/amp meter.
Repair/replace faulty broken wire.
1. Remove motor and replace damaged motor
mounts.
2. Replace blower wheel.
1. Remove and replace motor.
2. Replace blade if necessary.
3. Clean air mover blade.
1. Replace motor.
2. Remove obstruction.
3. Reduce duct length to recommended maximum