Clockaudio SM80 Series User manual

A low prole through table shock mount microphone base ed with a ip cover to conceal the
connector when closed.
 Designed for remote switching.
 Low prole table mounted microphone base.
 Requires a minimum table thickness of 25mm (1”)
 Includes a concealed ap to allow the table to be
used for other purposes.
 Built in shock mount to eliminate surface bound
noise.
 Fied with momentry (PTT) or latching switch.
 Bi-colour common anode LED to conrm status
 Housing PPA-RF for use with Clockaudio mics C
3100, C 310R, C 313/SR, C 314/SR.
 Terminated with RJ 45 connector and supplied
with RJ 45 coupler which allows connecon via RJ
12 or RJ 45 plug back to dsp.
Switch connecons
Architects and Engineers Specicaons for Mi-
crophone Shock Mount SM 80S-RF
It shall come complete with a dedicated phan-
tom power adaptor designed to power the C
3100 miniature gooseneck microphones termi-
nated with Tini Q 3 pin connectors. The Phan-
tom power adaptor shall accept 9 to 48 volts DC
and have impedance of 200 ohms. The phan-
tom power adaptor shall also include lters,
which shall eliminate all GSM frequencies from
800-1200 MHz and be terminated with a male 3
pin XLR. The microphone shock mount shall be
available in san Nickel or Black Nextel nishes.
The through table microphone shock mount
shall be a Clockaudio SM 80S-RF.
Applicable for Clockaudio microphones only
3 Pin Tini Q Wiring 3 Pin Male XLR Wiring
PIN 1 Phase – PIN 1 Ground
PIN 2 Phase + PIN 2 Phase +
PIN 3 Ground PIN 3 Phase
www.clockaudio.com

Installaon Guide (illustraons show SM80S)
1) Ensure minimum table thickness of 25mm
(1”).
2) Drill a 50mm (2”) hole through the table
see g A.
3) Remove the 3 M3 pan headed screws from
the boom plate see g B.
4) Remove the 2 M3 x 30mm pan headed
screws securing the base plate to the top
assembly see g C.
5) SM80S Only----Select the LED voltage by
moving the jumper to the required
posion see g D.
6) Fit the top assembly through the 50mm
(2”) hole see g E.
7) Re-t the base plate to the assembly using
the 2 M3 x 30mm screws adjusng the
nuts to clamp the top assembly and the
boom plate to the table ensuring that the
top assembly is correctly aligned before
nally ghtening the nuts see g F.
8) Re-t the boom plate to the shock
mounts using the 3 M3 pan headed
screws. Adjust the height of the PPA-RF
and secure with nut supplied see g G.
9) Installaon complete see g H.