Clover WW2000 User manual

I. Receiver (WW3000R)
1. Components
① Channel /Scanning Selection Button
② Power Button
③ Channel Indicator Lamp
④ Scanning Interval Time Indicator Lamp
⑤ Scanning Indicator Lamp
⑥ Infrared Emitting Window
⑦ Rectangle Antenna
⑧ Pull-shaft Antenna
⑨ IR Jack
⑩ Audio Left Output Jack
○
11 Video Output Jack
○
12 Audio Right Output Jack
○
13 Power Input Jack
○
14 Power Indicator Lamp
○
15 Infrared Emitting Window
Re a r
Front
Remote Controlle
r

II. Transmitter --- Camera (WW2000)
1. Component
① Power Button
② Focus Adjustor
③ Camera Lens
④ Infrared Emitting Tube
⑤ Indicator Lamp
6.Crophone
7. RectangleAntenna
8. Input Jack of Power DC 12V
9. Channel Selector
1) Use the pin of power line with adaptor to insert into the jack ⑧, and plug the power
supply to connect the camera.
2) Press the Button ①to open the power then the indicator lamp ⑤will be bright.
3) Adjust the Channel Selector ⑨to the corresponding channel of monitor.
4) If the monitor is working, it will display the picture which camera was taken.
5) Adjust the Focus Adjustor ②to get the clearest image (when first time do it, then

afterward do not need to re-adjust it).
6) Place the camera in the far site, and synchronously adjust its antenna ⑦and monitorˊs
to get the clearest image.
7) You can also adjust the direction and the up-angle of camera when you need.
1) Connect the Video Output Jack ○
11 and Audio Output Jack ○ 10 /○ 12 to the Input jack of displaying
equipment (e.g. TV set, LCD, Overhead Projector, and Multimedia Computer, etc.) by an AV
signal line. Audio signal (L & R) can be singly connect to Stereo Device. Pull up the 2.4G
Rectangle Antenna ○
7, connect the power supply by a power line with adapter, and after press
down the Power Button ○
2, there will be appear a wonderful picture on screen, issue a pleasant
sound from the louder speaker.
2) If there is two-sets unit work on the same place, for erasing the interference from same channel,
you can respectively adjust the camera’s channel and press scanning button ○
1to difference
channel from another (Please note the Transmitter and Receiver must being wok in the same
channel). Carefully adjust the rectangle Antenna ○
7of both units can get the best receiving
effect.