CMA Dishmachines L-1X-16 Manual

Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
5
STEP
BLUE RED WHITE
1
STEP
Connect 110/120V, 60HZ hard wired power
supply to power box. DO NOT USE POWER
CORD OR GFI OUTLET.
Connect dishmachine to hot water source
recommended 140
0
temperature (120
0
minimum temperature required).
STEP
2
L -1X16 / L -1X
Quick Setup
Instructions ELECTRICAL
CONNECTION 1
TUBE
STIFFENER 5
CHEMICAL
TUBING 5
DRAIN HOSE
CONNECTION 4
1/2" WATER INLET
2
LEVELING LEGS
3
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back to
ensure proper performance.
3
STEP
L-1X16 LEG
ADJUSTER
L-1X LEG
ADJUSTER
Connect the drain hose to wall or floor drain.
The floor drain must have a 1 inch air gap
between drain hose and floor drain.
WALL DRAIN FLOOR DRAIN
1"AIR GAP
4
STEP
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
5-2015
REAR VIEW
800-854-6417
HOT
NEUTRAL
GROUND

5-2015
L -1X16 / L -1X
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
FRONT VIEW
DRAIN
POWER
DETERGENT
PRIME SWITCH
SANI
PRIME SWITCH
RINSE
PRIME SWITCH
FILL / START
6
7
7
7
8
DELIMER
TO OPERATE MACHINE
SET SWITCH TO
NORMAL
CHEMICAL PUMPS
6
STEP
Turn power switch to "ON" position.
OFF POWER ON
DRAIN
FILL/START
Hold down "FILL" Switch for approximately 10 - 15 seconds to allow water to flow
into the dishwasher. Water should reach “FILL LINE” which is located
inside at the back of the wash tank. Close door, then press “START” switch.
NOTE: The 4th cam of timer assembly has to be adjusted to maintain the same
water level during the cycle.
8
STEP
OFF POWER ON
DRAIN
FILL/START
FILL LINE
Press and Hold down "SANI", "DETERGENT"
and "RINSE" switches to prime chemicals.
This step must be repeated each time
chemical containers are changed.
7
STEP
800-854-6417