CMA Dishmachines UC65e Manual

1-2010
3
STEP
4
STEP
UC65e
Quick Setup
Instructions
ELECTRICAL
INLET
1
STEP
WARNING: Electrical and
plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical,
Plumbing and Safety
codes.
800-854-6417
LINE 1
LINE 2
NEUTRAL
GROUND
115/208/230V
EXT WASH DRAIN START POWER
ON OFF
PRIME
EXT
R/A
2
STEP
Connect the drain hose to wall or floor drain. The
floor drain must have a 1 inch air gap between
drain hose and floor drain.
FLOOR DRAIN
1"AIR GAP
WALL DRAIN
ELECTRICAL CONNECTIONS
LOCATED INSIDE FRONT
PANEL
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back to
ensure proper performance.
Connect lines 1 and 2 to electrical block located
inside front panel.
Connect dishmachine to hot water source, minimum
temperature 120F, better results at 140F.
LEVELING
LEGS 3
1/2" WATER
INLET 4
3/4" DRAIN
OUTLET 2
1
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901

EXT WASH DRAIN START POWER
ON OFF
PRIME
EXT
R/A
9
STEP
UC65e FRONT VIEW
5
STEP
START
POWER 5
EXTENDED
WASH
7
DRAIN 9
6
WASH TEMP
RINSE TEMP
FINAL RINSE
1-2010
7
STEP
UC65e
Quick Setup
Instructions
WARNING: Electrical and
plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical, Plumbing
and Safety codes.
800-854-6417
6
STEP
EXT WASH DRAIN START POWER
ON OFF
PRIME
EXT
R/A
EXT WASH DRAIN START POWER
ON OFF
PRIME
EXT
R/A
EXT WASH DRAIN START POWER
ON OFF
PRIME
EXT
R/A
EXT WASH DRAIN START POWER
ON OFF
PRIME
EXT
R/A
DETERGENT
RINSE/PRIME
OVERFLOW
TUBE
Push the power button to turn on the dishmachine.
Wash tank will fill automatically.
Push button to change time cycle. Push to the "IN"
position to run for 120 seconds and the "OUT"
position for 180 second run.
Push the "START" button to activate the
dishmachine.
With the overflow tube removed, push drain button
to empty dishmachine. Reinstall overflow tube when
drain cycle is complete.
8
STEP
Push the power button (STEP 5) to turn power off.
When draining the dishmachine, remove overflow
tube located inside the wash tank.
8
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901