CMA Dishmachines CMA-180UC Manual

2
STEP
Connect hard wire power supply from dishmachine
to power box. (Two hot wires, one neutral and one
ground.)
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back.
Connect dishmachine to hot water source, minimum
temperature 140∞. If 140∞is not available, order a 3
minute timer cycle (120∞minimum temperature
required).
When ever possible, remove pump drain if a floor
drain is available near by. Remove drain pipe and
place drain hose on the drain valve and allow
machine to gravity drain.
3-2007
3
STEP
4
STEP
180UC
Quick Setup
Instructions
180UC REAR VIEW
NEUTRAL
HOT
GROUND
DRAIN HOSE
HARD WIRE
FOUR WIRE
POWER SUPPLY
1/2" WATER INLET
DRAIN VALVE
RINSE
INJECTION
110V POWER
CONNECTION
FOR DISPENSER
DETERGENT
INJECTION
WASH
SENSOR
RINSE
SENSOR
PUMP DRAIN
MOTOR
LEVELING
LEGS
1
2
3
4
1
STEP
FLOOR DRAIN
1"AIR GAP
Connect the drain hose to wall or floor drain. The
floor drain must have a 1 inch air gap between
drain hose and floor drain.
WALL
DRAIN
WARNING: Electrical and
plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical,
Plumbing and Safety
codes.
5
STEP
5
5
800-854-6417
Adjust pressure regulator located behind side panel,
to 20 psi (maximum).
8
STEP
Turn power switch to "ON" position. Hold down
"FILL" switch until water overflows into the scrap
drawer.
9
STEP
After filling dishwasher for the first time, (CAUTION:
turn power supply off) reconnect the factory
unplugged wire to booster high-limit switch located
behind front panel.
180UC FRONT VIEW
WASHTEMP 150 -160 FINALRINSE TEMP 180 -195 POWER
OFF DRAIN START
CYCLE
FILL
ON
RINSE
TEMPERATURE
DISPLAY
POWER
SCRAP
DRAWER
WASH
TEMPERATURE
DISPLAY
RINSE
PRESSURE
GAUGE
START
6
STEP
Chemical dispenser electrical hookup is located
inside control box. Chemical dispenser is optional.
It is not sold with dishmachine.
RINSE DETERGENT
ELECTRICAL
BLOCK 6
DRAIN FILL 8
BOOSTER
HIGH LIMIT
SWITCH
9
FILL
3-2007
7
STEP
20
PRESSURE
REGULATOR
(Located behind
side panel)
7
180UC
Quick Setup
Instructions
WARNING: Electrical and
plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical, Plumbing
and Safety codes.
800-854-6417