CMi PC-66L User manual

Product Overview1.
Charging3.
4. How to Use and Take
a Measurement
Display Screen
Data interface
Navigation Key
Mode/OK
Power/Back
Charging Port
Recall/Mute
SpO2Probe
Connector
Screen Display2.
Pulse rate
symbol
Pulse strength
bar graph
Sound
indicator
Patient TypeCurrent SpO2lower
alarm threshold
Current
time
SpO2
Value
SpO2
Mark
Pulse
Plethysmorgram
Pulse rate
value
Battery
indicator
Memory
full icon
Pulse Rate
Mark
To charge the battery, connect the end of the charging
cable to the device’s top DC power input (round charging
port), and connect the other end to the AC power adapter.
Any questions?
Contact us at:
Email: [email protected]
Phone: [phone]
Fax: [phone]
cmihealth.com
Line up arrow signs, then insert cord.
Open cap and connect converter cable with the other end
of SpO2sensor.
Insert one finger into the sensor and start your
measurements.
Charging Port

PC-66L Quick Guide
Mute Beeping Sound
6.
5. Alarm Set-up
Press and hold ”Mode/OK” for 2
seconds to go to the menu.
1.
• Short press the mute button to mute the beeping sound.
• Alarm sound will go off if measurement is out of limit or
sensor fell off. You can adjust the alarm thresholds based
on your need.
*Please be aware that the mute function would be
overwritten by alarm onset or power off. Short press the
mute button again if either situation occurs.
On the menu screen, select “Setting”
and then press “Mode/OK.”
2.
Menu
Setting
Upload data
Default
Español
Setting
Patient
SpO2Lo-Limit
PR Hi-Limit
PR Lo-Limit
ADU
90%
120
45
Use / to move cursor and select type
of threshold for alarm. Example shows
SpO2Lo-limit.
3.
Once confirmed, press “Mode/OK”
to save change and (power/back) to
exit from alarm setting.
5.
Setting
Patient
SpO2Lo-Limit
PR Hi-Limit
PR Lo-Limit
ADU
88%
120
45
Press ‘Mode/OK” to change default
value. A highlight will shows on the
screen, and use /to adjust to desired
threshold value. (see pg.13 in user
manual for more details).
4.