CNP Brands Childcare 056201-003 User manual

IMPORTANT:
RETAIN FOR FUTURE REFERENCE,
READ CAREFULLY
Childcare
Baby Bath and Stand “White”
Model # 056201-003

2
This product has been manufactured for a child with a maximum age of 12 months or a maximum weight
of 11kgs.
Be aware of the risk of open res and other sources of heat,such as electric bar res,gas res,etc.in the near
vicinity of the bathing unit.
Use original accessories and manufacturer approved parts only.
DO NOT use this bath & stand if any part is broken or missing.
ENSURE that the bath & stand is completely assembled and check that all parts are securely tightened
before use.
Regularly check all parts for tightness - tighten or replace if required.
Promptly replace worn or broken parts.
Babies and young children are at risk of drowning when being bathed.
NEVER use this product on an elevated surface not intended for this product.
To avoid scalding by hot water, position the product in such a way to prevent the child from reaching the
source of water.
ALWAYS check the water temperature before bathing the child.
ALWAYS check the stability of the product before use.
Read all instructions before assembly and use of the Baby Bath & Stand.
Keep instructions for future use.
WARNING - DROWNING HAZARD:
• CHILDREN CAN DROWN IN AS LITTLE AS 2cm OF WATER IN A VERY SHORTTIME.
• ALWAYS REMAIN IN CONTACT WITH YOUR CHILD DURING BATHING.
• NEVER LEAVEYOUR BABY UNATTENDED IN THE BATH, EVEN FOR A FEW MOMENTS.IFYOU
NEEDTO LEAVETHE ROOM,TAKE THE BABY WITHYOU.
FOLLOWTHE MANUFACTURER’S INSTRUCTIONS.
DO NOT LEAVEYOUR CHILD UNATTENDED.
CHILDREN HAVE DROWNED WHILE USING BATH AIDS.
THIS IS NOT A SAFETY DEVICE.
ALWAYS KEEPYOUR BABY WITHIN ARM’S REACH.
NEVER LEAVEYOUR BABY INTHE CARE OF CHILDREN.
DO NOT ALLOW OLDER CHILDRENTO CLIMB OR PLAY ONTHE BATH & STAND.
SAFETY PRECAUTIONS
WARNING

3
Due to variations in the style and design of our products, the photographs and illustrations shown in this
instruction manual are generic,therefore product fabrics,colour and design may vary from images shown.
CNP Brands reserves the right to alter product specications without notice as a result of our ongoing
policy of product improvement.
Contents
Assembly contents list
Assembly / Operating instructions
How to care for your Childcare Baby & Stand
Congratulations on your purchase of the Childcare
Baby Bath & Stand “White”.
This product has been designed and developed with safety,
comfort and functionality in mind. Please take the time to read
this manual carefully before using this product and keep it in a
safe place for future reference.
CONGRATULATIONS

4
ASSEMBLY CONTENTS
Check what you have received...
You have received 1 box. Please check the contents of the
box against the list below. If anything is missing, please contact
Customer Service.
InAustralia,contact CNP Brands on 1300 667 137,in New Zealand
contact Wainhouse Distribution on 0800 567 5000.
Supplied loose in box:
Bath Stand
Bath Plug
x 1
x 1
x 1
x 4
Bath
Legs
There are no accessories recommended for use with this Baby Bath & Stand.

5
ASSEMBLY / OPERATING INSTRUCTIONS
To assemble Frame...
1
2
3
4
Grasp the top of both sides of the Bath Stand.
Pull outward until Bath Stand opens and locks
into place.
Push down on frame lock to ensure lock is fully
secure.
Lay Bath Stand on its side.
Align one Leg with one end of the Bath Stand.
Insert Leg into the end of the Bath Stand,until
the pop-pin‘clicks’ into position.
Repeat for remaining 3 Legs.
Stand Bath Stand upright.
1a.
1b.
1c.
2a.
2b.
3a.
3b.
4a.

6
ASSEMBLY / OPERATING INSTRUCTIONS
1
2
Insert Bath into the top of the Bath Frame,
ensuring that all 4 feet sit at and secure on Bath
Frame platform.
Ensure the higher end of the Bath corresponds
with the higher end of the Bath Frame.
Insert Bath Plug into Bath drainage hole.
To assemble Bath...
1a.
1b.
2a.
1
2
Remove Bath from the Bath Stand.
Push frame lock upward to unlock.
Grasp the top of both sides of the Bath
Stand.
Push sides towards each other to fold
frame for storage.
1a.
2a.
2b.
2c.
To fold Bath Stand...

7
HOW TO CARE FOR YOUR CHILDCARE CHANGE CENTRE
Cleaning
Maintenance
This product has been designed and developed with safety, comfort
and functionality in mind. Please take the time to read this manual
carefully before using this product and keep it in a safe place for
future reference.
To ensure the long-lasting use of your change centre, wipe down
with a damp cloth and use a mild soap solution if necessary. Do not
use abrasive cleaners.Always store product in a clean dry place.
Always check parts regularly for tightness of screws, nuts and other
fasteners – tighten or replace if required. To maintain the safety
of your change centre seek prompt repairs for bent, torn, worn or
broken parts. Use only those parts and accessories approved by
CNP Brands.
If you have any difculties in assembling the change centre, please
contact our Service Department.
In Australia, contact CNP Brands on 1300 667 137, in New Zealand
contact Wainhouse Distribution on 0800 567 5000.

Distributed in Australia by CNP Brands
Customer Service 1300 667 137
W: www.cnpbrands.com.au
E: [e-mail]
F: www.facebook.com/CNPBrands
I: @cnp_baby
Distributed in New Zealand by Wainhouse
Distribution
2-6 Argyle St, Morningside,
PO Box 41-014,
St Lukes,Auckland, New Zealand
Customer Service: 0800 567 5000
E: [e-mail]