Coaster 100775 User manual

100775
SERVER.
www.coastercompany.com
COASTER FINE FURNITURE
ASSEMBLY INSTRUCTIONS
PAGE 1 OF 4
REVISION 0 : 08/01/2017

2. Please check to see that all hardware and parts are present prior to start of assembly.
2. This product is for home use only and not intended for commercial establishment.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
1. Remove hardware from box and sort by size.
PARTS IDENTIFICATION:
A
immediately.
ASSEMBLY TIPS :
100775
Warning !
ITEM :
PAGE 2 OF 4
www.coastercompany.com
SERVER
ASSEMBLY INSTRUCTIONS
1PC
X
STEP 1
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
PROCESS; HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
ASSEMBLY TIME 15 MINUTES
3SETS
KNOB WITH SCREW
X
A

www.coastercompany.com
PAGE 3 OF 4
100775
ITEM : ASSEMBLY INSTRUCTIONS
STEP 3
STEP 4
Adjust the height of shelf support.
Align and fasten shelf support to shelf using screw and fully tighten with Phillips head screw driver
(NOT INCLUDED)
STEP 2
STEP 3
STEP 4
STEP 2
To remove the shelf,unscrew the shelf from shelf support using Phillips head screw driver (NOT INCLUDED)

PAGE 4 OF 4
ANTI - TIPPING KIT
www.coastercompany.com
PARTS IDENTIFICATION: HARDWARE IDENTIFICATION:
ASERVER 1PC
2
SHORT SCREW 1PC
3
LONG SCREW 1PC
4
CABLE TIE 1PC
1
L BRACKET 2PCS
STEP 2
STEP 1
This tip restraint must be attached to a wall
stud using long screw enclosed.
Attach a bracket securely to the back top rail of the server
using short screw provided, through the smaller hole.
Locate the other bracket on the wall over a wall stud and two
inches below the mounting bracket secured to the back of
server. Attached to the wall stud using the long screw
provided, through the smaller hole.
1WALL
A2
4
4
STEP 3
Place the server into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the
larger hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it
through until all slack is removed. Confirm that the strap is securely laced and locked.
3
WALL