Coaster 204393 User manual

COASTERFURNITURE.COM
Fine Furniture for every stage of life
REVISION 1 : 01/21/2020
REVISION 0 : 10/30/2015
PAGE 1 OF 5
204393
Dresser
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE

DRESSER
A1PC
COASTERFURNITURE.COM
RIGHT FRONT LEG
(WITH FR LABEL)
B 1PC
C 1PC
D1PC
E 1PC
LEFT FRONT LEG
(WITH FL LABEL)
RIGHT BACK LEG
(WITH BR LABEL)
LEFT BACK LEG
(WITH BL LABEL)
PAGE 2 OF 5
FSUPPORT LEG 1PC
WARNING !
1 . Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2 . This product is for home use only and not intended for commercial establishment.
ASSEMBLY INSTRUCTIONS
1 . Remove hardware from box and sort by size.
2 . Please check to see that all hardware and parts are present prior to start of assembly.
3 . Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
ASSEMBLY TIPS:
ASSEMBLY TIME 20 MINUTES
ITEM: 204393
PARTS IDENTIFICATION
HARDWARE IDENTIFICATION
BOLT
(M6 x30mm - BLK)
1 8PCS
LOCK WASHER
(1/4" - BLK)
2 8PCS
FLAT WASHER
(1/4" x20mm - BLK)
8PCS
ALLEN WRENCH
(M4 x 65mm - BLK)
4 1PC
3
NOTE:
Philips head screw driver in the assembly process ; however, manufacturer does not provide the item

PAGE 3 OF 5 COASTERFURNITURE.COM
A
C
B
E
D
3
2
1
4
4
1
2
3
ASSEMBLY INSTRUCTIONS
ITEM: 204393
STEP 1
STEP 2
F
A
2.2
2.1

PAGE 4 OF 5 COASTERFURNITURE.COM
ASSEMBLY INSTRUCTIONS
ITEM: 204393
COMPLETE
STEP 3

WARNING
Injury may result from tipping furniture.
This restraint may protect against tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitle for proper adult supervision.
Failure to detach this restraint before moving the furniture may result in injury and damage.
FURNITURE TIPING RESTRAINT
This tip restraint must be attached to a wall
stud using long screw enclosed.
STEP 1
Attach a bracket securely to the back top rail of the
dresser using short screw provided, through the
smaller hole.
STEP 2
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of dresser. Attached to the wall
stud using the long screw provided, through the
smaller hole.
WALL
A
STEP 3
Place the dresser into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide the
flat end through the locking end and draw it through until all slack is removed. Confirm that the strap is
securely laced and locked.
WALL
PAGE 5 OF 5 COASTERFURNITURE.COM
ITEM: 204393
ANTI-TIPPING INSTALLMENT INSTRUCTIONS

ITEM: 204393
Note:Dimension tolerance ±5%
COASTERFURNITURE.COM
INNER SIZE OF DRAWER : 5.27" X 12.67" X 24.01"
16.53"
59.05"
0.74"
32.40"
36.77"
48.63"
9.26"
3.46"
25.47"
8.22"