Cobra RAD 480i User manual

RADAR/LASER DETECTOR
QUICK START GUIDE
RAD 480i
4 6
VOL
4 6
VOL
4 6
VOL
Attach Hook & Loop to Detector
1Hook & Loop
Attach Detector to
Dashboard Surface
2
Windshield
Dashboard
3Connect Detector to
12V Power Source
Connecting your Detector to your
Smartphone via Bluetooth®
A
Share and receive red light, speed camera and live
enforcement alerts from the iRadar driving community.
Power on RAD 480i - Make sure the unit
is connected to your car’s 12V port.
Note: the rst time RAD 480i is powered
on, you will be prompted to select your
time zone and daylight saving time
Install and run the Cobra iRadar
app on your smartphone
Note: the rst time you run the app, you
will be prompted to register a new account
In the iRadar app, press the Menu
button then select "Devices"
Select "RAD 480i" from the list
In the iRadar app, the RAD 480i entry will
display "Connected" when it has paired.
Press the “Menu” button then “Home” to
return to the Map screen.
You’re all set!
4
6
1
2
3
5
Dashboard Mounting Option -

DIM SEN
MUTE
MARK MENU
Windshield Mount Slot
Speaker
Brightness
Display Mute
Volume Up/Down/Power
Sensitivity
THANK YOU!
For purchasing the new
COBRA®RAD 480i
Full manual available at: www.cobra.com
©2020 Cobra Electronics Corporation Printed in the Philippines
Cobra®, iRadar®and the snake design are registered trademarks of Cobra Electronics
Corporation, USA.
Cobra Electronics Corporation™ is a trademark of Cobra Electronics Corporation,USA.
Other trademarks and trade names are those of their respective owners.
FCC ID:BBOIRADD5. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTEFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC NOTE: Modications not expressly approved by the manufacturer could void the user's FCC granted authority to operate the equipment.
4 6
VOL
RAD 480i Features
Windshield Mount Release
12V Power Port
12V Power CordWindshield Suction Cup Bracket
Mark Menu
Assemble Suction Cup Bracket
1
Attach Suction Cup Bracket
to Windshield
3
Windshield
Adjust Suction Cup Bracket
to ensure your RAD 480i has a
level view of the road
2
4 6
VOL
Attach RAD 480i to
Suction Cup Bracket
4
5Connect Detector to
12V Power Source
micro USB Port
Windshield Mounting Option -