Cobra WASPcam 9820WR User manual

UserManual
RemoteControl
WASPcam9820WR
NOTE**:Before pairingthe remote to the camera,formatthe MicroSD card inthecamera.
HowToPair theRemote:
1. Whenthecamerais in standbymode,press themenubuttontwicetoenter
systemsettings.
2. Presstheleft/right arrowbuttonstoscroll through themenu,chooseremote
controltoentertheremotemenu.Then select RemoteMatch.
3. Amessagewill appearon theLCD Screen WaitRemoteMatch”,thecamerais
nowin pairingmode.
4. At thesametime, press bothbuttonsontheremotecontrollertostart
pairing. PairingissuccessfulwhentheLCDscreen shows RemoteMatch
OK”
1 - Indicatorlight
2 –Photo Button- press totakephotos,
PresstheInquiry/RecordButton(3)andthePhoto
button (2)simultaneouslyto enterPairingmode
3 –Inquiry/Record Button –press to start/stop
recording,press andhold for3 secondsto check
thepresent statusof thecamera(see below)
RemoteControlIndicator Light Status
Status/LED Red LED Light BlueLEDLight
Standby 1 time/secfrequently
Flickersabout 5sec Off
Recording Off Light on3 seconds, then off
StatusInquiry
Power off Light on3 secs, then off Off
Pairing Longlight Longlight
Success Light on3 secs, then off Light on3 secs, then off
PairingMode Failure Off Off

FCCStatement
Thisdevice complieswithpart15 oftheFCCRules. Operation issubjecttothe
followingtwoconditions:(1)Thisdevice maynotcauseharmfulinterference,and (2)
thisdevice mustacceptanyinterferencereceived, including interferencethatmay
causeundesired operation.
Thisequipmenthasbeentestedand found tocomplywiththelimitsforaClass B
digitaldevice,pursuantto part15 oftheFCC Rules.
Theselimitsare designedtoprovidereasonableprotection againstharmful
interferenceinaresidentialinstallation. Thisequipmentgeneratesusesand can
radiateradiofrequencyenergyand,ifnotinstalledandusedinaccordance withthe
instructions, maycauseharmfulinterference toradiocommunications.However,
there isno guarantee thatinterference will notoccurinaparticular installation. Ifthis
equipmentdoescauseharmfulinterference toradioortelevision reception, whichcan
bedeterminedbyturningtheequipmentoffandon, theuserisencouragedtotryto
correcttheinterference byoneormore ofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparation between theequipmentand receiver.
Connecttheequipmentintoanoutleton acircuit differentfromthattowhichthe
receiver is connected.
Consult thedealer oran experienced radio/TVtechnician forhelp.
Changesormodifications notexpresslyapprovedbythepartyresponsiblefor
compliance could void theuser's authorityto operatetheequipment.
Startrecording 2 times/secfrequent
Flickersabout 5sec Off
Stoprecording 1 time/secfrequent
Flickersabout 5sec Off
Photo Off Flashesonceeachtimeyou
takeaphoto

ICStatement
Thisdevice complieswithIndustryCanada’slicence-exemptRSSs.Operation is
subjectto thefollowingtwo conditions:
(1)This devicemaynotcauseinterference;and
(2)This devicemustacceptanyinterference, includinginterfe
Theterm “IC: “beforethecertification/registration number onlysignifiesthatthe
IndustryCanadatechnicalspecifications were
met.This productmeets theapplicableIndustryCanadatechnicalspecifications.
Leprésentappareil estconformeauxCNRd'IndustrieCanadaapplicableaux
appareils radio exempts delicence.
L'exploitation estautoriséeauxdeuxconditions suivantes:(1)l'appareil nedoit pas
produire debrouillage,
et(2)l'utilisateurdel'appareil doit accepter toutbrouillageradioélectriquesubi, même
silebrouillageestsusceptibled'en
compromettre lefonctionnement