Code Alarm UTXPR Owner's manual

TRANSMITTER PROGRAMMING
Note: This mode will only retain the last 4 remote transmit-
ters programmed. If the transmitter memory is exceeded,
the security system will start deleting transmitters from
memory in chronological order.
To program transmitters:
1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp/flash the parking
lights (3) three times, release the button.
4. Press Button 1 of each transmitter you wish to program.
The system will respond with 1 chirp for each accepted
transmitter (up to 4).
5. Turn the Ignition OFF to exit programming. The system will
also exit programming after 15 seconds of inactivity.
Note: This system has 1 button programming which pro-
grams all channels of the system.
Technical Support
[phone]