Coinco 9302-GX User manual

FEATURES
 Accepts U.S. nickels, dimes, quarters and
dollar coins.
 Pays out nickels, dimes and quarters from
self-loading, high-capacity change tubes.
 Select high or low quarter tube le el with
the flip of a switch.
 Dollar coins can be rejected by simply
flipping a switch.
 Hea y duty D.C. payout solenoids pro ide
fast, accurate payout.
 State-of-the-art electronic logic system is
designed for reliability and performance.
The logic board is warranted for two
years.
 Lightweight, rugged, plastic construction
pro ides dependable, maintenance-free
ser ice.
 Pro ides the fastest and most accurate
coin acceptance of any electronic unit
a ailable today.
CAUTION: Do not plug or unplug changer
with power applied
9302-GX Coin Changer
34VDC  ulti-Drop Bus Interface
®

Figure 1
Coin Acceptors, Inc.  300 Hunter A enue  St. Louis, MO  63124-2013  [phone]
Coin Acceptors, Canada  237 Finchdene Square  Scarborough (Toronto), Ontario  M1X 1B9  [phone]
Coinco Publication No. 920859  Re . 3  9/97  Printed in the U.S.A.
INSTALLATION INSTRUCTIONS
1. Remo e the acceptor from the changer by
releasing the acceptor studs from the
changer latches and pulling the top of the
acceptor forward and away from the
changer. Unplug the ribbon cable from
the changer. Free the lower acceptor
studs from the changer housing. With the
acceptor remo ed, set the key holes in the
back of changer housing o er the
mounting screws in the endor. Tighten
snugly.
2. Set the desired changer options (see
Option Switch Setting section).
3. Replace the acceptor by inserting bottom
acceptor studs into changer housing
guides. Plug the acceptor ribbon cable
into the changer. Press the top of acceptor
into the changer housing until the top
acceptor studs lock into the changer's
acceptor latches.
4. Plug the changer into the endor socket.
5. Load the coin tubes making sure all coins
lie flat.
6. Test the changer with a ariety of coins to
ensure proper operation.
OPTION SWITCH SETTING
1. Unplug the coin changer.
2. Remo e the acceptor.
3. Located in the upper portion of the
changer is a single switch module with
three rocker switches (see Figure 1).
When the top of the rocker switch is
pushed in, it is in the ON position. For
information regarding switch settings,
see Figure 2.
4. Replace the acceptor.
5. Plug the changer into the endor socket.
6. Test with a ariety of coins to ensure
proper operation.
SWITCH A - NOT USED
SWITCH B - LO 25¢
Controls the le el of the 25¢ change tube.
ON Quarters are directed to cash box
once change tube has approximately
18 quarters.
OFF Quarters are put into change tube
until change tube is full.
SWITCH C - $ ACPT
Controls the acceptance of the dollar coin.
ON Dollar coin accepted.
OFF Dollar coin rejected.
Figure 2