Coleman KRYPTON 2 9870-240 User manual

Assemble Frame
– Insert one end of the Main Tent Pole tips into
the grommet on webbing located at the corner
of the tent. (illus. 3), (illus. 4)
– Go to opposite end of the Main Tent Poles and
gradually apply pressure to the pole, forming
an arch, until you are able to insert the pole tip
into the grommet on the corner web. (illus. 4)
– Repeat for second pole.
– Insert one end of Side Pole into grommet on the
webbing at the side of tent and go to opposite end
of the Side Pole and gradually apply
pressure to the pole, forming an arch,
until you are able to insert the pole
tip into the grommet. (illus. 4)
– Repeat for second pole.
Krypton 2
™
part number 9870-240
1
2
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors facing
desired direction. (illus. 1) Unzip doors.
– For best results in windy conditions, position
door or back of tent into the wind.
– Stake down tent corners. Keep the floor taut.
(illus. 2)
– Assemble Frame Poles by interlocking the
shock-corded sections. This will make two
long red Main Tent Poles and two long
silver Side Poles.
– Insert the two Main Tent Poles through the pole
sleeves with the red trim.
– Insert the silver Side Poles through the pole
sleeves with the silver trim.
Main Tent Poles (Red)
Part No. 9870-101
Side Poles (Silver)
Part No. 9870-102
Rainfly
Part No. 9870-110
illus. 1
illus. 2
Tent stake
through Loop
illus. 3
Insert Pole Tip on
stake loop into pole.
illus. 4
Tent frame up
POLE ASSEMBLY PARTS
Main Tent Poles
Main Tent Poles
Side Poles
Side Poles

Pro-Tips
• Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric.
Loosening Velcro at the top of both double-zippered vestibules, allowing good ventilation through the tent, can minimize condensation.
• Never store tent, even for a short period of time, without
drying it thoroughly and brushing off caked dirt. Do not pack
stakes or poles inside your tent. Use separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE
ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE
LOOP TO REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE. 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
3Attach Rainfly
– Drape Rainfly over tent frame, with
rainfly double zipper doors lining up
over tent doors. (illus. 5)
– Connect the six clips to the clips located
at the corners and sides of the tent.
(illus. 6 & illus. 7)
– Stake out rainfly doors, keep rainfly taut.
(illus. 7)
– Attach Guy Lines to Guy Wings on the
sides of the Rainfly and stake out
(illus.7).
illus. 5
Rainfly
illus. 7
Completed tent
with Rainfly.
Stake out door
and vestibule
Guy Line
Guy Wings
illus. 6
Rainfly clips
onto pole
stake loop
PRINTED IN CHINA
© 2005 The Coleman Company, Inc. All Rights Reserved.