Coleman HOOLIGAN 3 2000001590 User manual

7. Assemble thin, black, shock-corded Vent Pole.
8. Insert Vent Pole through
sleeve at back of tent.
(Fig. 5)
9. Insert metal tip into
grommet. Go to opposite
end of Vent Pole and
gradually apply pressure to
pole forming an arch then
insert metal tip into grommet.
(Fig. 6 & 6A)
Fig. 5
Back of Tent
Fig. 3
Stake Stake
Fig. 8
HOOLIGANTM 3MODEL 2000001590
STITCH LINE
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with the
door facing perpendicular to the wind direction. Unzip door.
2. Assemble Main Poles by interlocking the black, shock-cord-
ed, sections.
3. Insert Main Poles through sleeves in top of tent. (Fig. 1)
4. Insert one end of black main pole into pin on metal loop
located at either end of tent. (Fig. 2)
5. Go to opposite end of Main Pole and gradually apply pressure
to pole forming an arch. Insert pin into
the pole end (Fig. 2 & 3). Repeat for the
remaining Main Pole.
To Attach Rainfly
1. Drape Rainfly over tent. Make sure seams on Rainfly are
facing down and centered over poles and the vestibule is
over to door of the tent. (Fig. 7)
NOTE: Hook and loop fasteners, located on seams of under -
side of rainfly, should be centered over black poles.
(continued on other side)
Metal
Loop
& Pin
Main
Pole
Fig. 2
6. Stretch out corners and sides of
tent. Drive in stakes at an angle
through the metal loops to help
anchor the corners & sides of the
tent. (Fig. 3 & 4)
2. Fold Rainfly at front of tent back as shown in Fig. 8.
3. Assemble Vestibule Pole by interlocking the grey, shock-
corded, sections.
4. Insert one end of grey Vestibule Pole into pin on metal loop
located at either side of tent. (Fig. 8 & 8A)
5. Go to opposite end of Vestibule Pole and gradually apply
pressure to pole forming an arch. Insert pin into the pole end
(Fig. 8 & 8A).
Pole Descriptions
Pole Pole Pole
Description Qty. Dia. Repair Kit Replacement Kit
Main Pole, black 2 8.5mm 5010000541 5010000547
Vestibule Pole, grey 1 8.5mm 5010000541 5010000547
Vent Pole, black
with pre-bent ferrules 1 6.0mm 5010000639 5010000639
Fig. 4
Fig. 6
6A
Fig. 7
Front of Tent
Rainfly
Vestibule
over Door
8A
Grey Vestibule Pole
Front of
Tent
Door
Hook & Loop
Fasteners
Fig. 1
Sleeve
Door
Back of Tent
Main
Pole
Sleeve
Main
Pole
Sleeve Vent Pole
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
• For best results in windy conditions, position narrow end of
tent into the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.

STITCH LINE
8. Stretch elastic straps located on vestibule at front of tent and
all guylines, stretch until taut, and secure with stakes.
(Fig 11 & 11A)
Fig. 12
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2009 The Coleman Company, Inc.
Coleman®, , and are registered trademarks and HooliganTM is a trademark of
The Coleman Company, Inc.
4010003998 (20090515)
Fig. 11
11A
11B
Vestibule
Straps
Guylines
7. Attach the hooks on the
elastic straps located on the
Rainfly to the metal loops
on the web straps and the
four corners and sides of
the tent. (Fig. 10)
Fig. 10
To Store
1. All stakes and the main pole must be placed in the storage
bags to prevent damage to the fabric items placed in the
carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Neatly fold tent and rainfly, place main pole and stakes in
storage bags, then roll tightly and place in carry case.
4. Store in a clean, dry area.
Vestibule & Door Flap
The vestibule, on the front of the
Rainfly, provides privacy and space
for gear storage. The flaps may be
rolled back and secured for maxi-
mum air flow.
1. Unzip Rainfly vestibule, roll up
flap, then insert into pocket on
Rainfly to store (Fig. 12
& 13). Other side of
vestibule acts as a
windbreak.
The fabric door of the tent may be closed for maximum privacy
or unzip the vent fabric for increased ventilation.
2. Unzip door flap and/or the door vent,
roll up one or both flaps, then insert
toggle through fabric loops to secure.
(Fig. 14)
Fig. 13
Fig. 13
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
6. Secure all hook & loop fasteners, on the underside of the
Rainfly, to the Vestibule Pole, Main Poles, and Rear Vent
Pole. (Fig. 9, 9A & 9B)
NOTE: The longer hook & loop fastener, shown in Fig. 9B,
must wrap around the Main Pole and the Vestibule Pole to
add more strength to the tent.
To Attach Rainfly (continued)
Hook & Loop
Fasteners
9A
Longer Hook &
Loop Fasteners for
crossed Poles
9B
Fig. 9