Collingwood Lighting DMXT User manual
DMXT
INSTRUCTIONS
tel + 6 fax + ( 6
CWI V
Read all of these instructions before commencing installation.
THIS UNITWILL FIT A SINGLE RECESSED PATTRESS BOX MINIMUM DEPTH MM
IT IS NOTSUITABLE TO FITTO A SURFACE MOUNTED PATTRESS BOX.
NOTE: PATTRESS SCREWS ARE NOT PROVIDED.
The minimum depth quoted does not allow the 12Vdriver to fit inside the paress box.The driver must be located in a suitable position. A paress box
of minimum depth 50mm will be needed to locate the driver inside the paress box. Care must be taken that the driver is not damaged when screwing in
the paress screws.
INSTALLATION
1. Install two wires to the paress box
i. For 12VDC supply to the DMXT. The 12Vdriver is supplied with the DMXT.
ii. DMX cable for the DMX signal output.
2. Disassemble the unit by:
i. Pulling off the frame.
ii. Separating the DMXTand back plate by pushing on the green terminal block.
3. Fix the DMXT back plate to the paress box with standard paress box screws (not provided) as shown below, with the widest slot on the le.
4. Connect the 12V DC supply to the DMXTconnections marked + and -, ensuring correct polarity is maintained.
5. Connect the DMX cable to the terminals marked DMX A and B, plus the ground if being used.
6. Connect the driver to the mains supply. Ensure mains supply is isolated before doing this.
tel + 6 fax + ( 6
CWI V
8. Insert the DMXT into the back plate and secure it by push fiing the frame.
Use the white or silver frame as desired.
OPERATION
1. Select colour by touch on ‘rainbow’ disc.
2. On/Off
3/4. Dim up/down when on static colour.
Cycle faster/slower when on colour cycle.
5. Colour cycle
6. Memory.
Long press (until LED flashes) - Memorise colour.
Short press - Recall last 6 memorised colours.
7. Select primary colours and white.
7. The other end of the DMX cable will connect to either:
i. RGBox 55 (24V) - DMX input terminals are marked A & B, or
ii. DMXI (350mA). Discard the instructions supplied with the DMXI and connect as shown below.
DMXT
INSTRUCTIONS
Table of contents
