Products and specifications are subject to change without notice
Due to the manufacturing processes of LED, the polar candela distribution and distance luminaries only
reflect statistical figures and do not necessarily correspond to the actual parameters of Individual product
that may differ from the typical values.
Thank you for purchasing the Colordreamer LED Wall Washer
Our manual will describe the installation and mounting of the product as well as a descriptio
n of how to use it.
Please read and understand this manual in its entirety before using the product.
Product Warranty is void if product is not installed as per installation instructions and in
compliance with all local and provincial codes.
SAFETY RECOMMENDATIONS AND WARNINGS
Do not make modifications or alter the product
Keep away from flammable material.
Do not hose or pressure clean.
Do not use any silicone or other chemicals on outside surface.
Do not use chemicals or abrasives to clean the luminaires as this many voids the warranty.
Ensure installation complies with local electrical rules and regulations.
Ensure mains input power is surge protected
Do not connect or disconnect the luminaire while the power is connected.
Connectors are to be kept clean and dry at all times.
Input Voltage range 20-24VDC
Once installed, all connectors are to be mated and a terminating plug or end cap is required
on the last fitting of run.
When placing the luminaries in an end-to-end setup, be sure to leave a minimum gap of
10mm to allow the thermal expansion
Colordreamer Products are cooled by convection. Provide adequate ventilation by providing
free air flow around.
If the ambient temperature around the luminaires exceeds 55degrees, do not use the
products and turn off the system.
Power off the luminaires during service or when not in use.
