Colortac SmartLF Scan! User manual

1
.
For SmartLF Scan!
Large Format Scanner
I
nstructions
for
Scan to PC via Network

To Scan to Computer (via Network):
REQUIREMENTS
1. You need a 1GB Network connection (or to directly connect to a 1GB Switch)
2. You need to install the NetApp software on the Computer
NETWORK CONFIGURATIONS
There are two ways to configure the Network Connection
1. Connect via DHCP settings
2. Connect via Static settings
DHCP Connection
With DHCP connection –your Server will issue an IP Address to the scanner and to your PC
When using DHCP –no need to set any IP Address or Subnet Mask at the scanner or PC
Simply choose DHCP for the scanner (see below)
(confirm your PC is set for DHCP) –then reboot the PC and Restart the Scanner
Choose
You must have a 1GB Network connection
You Must install the NetApp program on the PC
–make sure it is OPEN (and configured) before you try to scan (see below)

STATIC Connection
With STATIC connection –you will manually set an IP Address and Subnet Mask Address for
the scanner and for your PC
-The PC and Scanner must be configured for sequential Static IP Addresses and both must
be configured for the same Subnet Mask number
-
For example –Set Scanner to IP address –192.168.001.111 -
Set PC to IP address - 192.168.001.112
Set both Scanner and PC to Subnet Mask of –255.255.255.0
Manually enter a Static IP address –then press
Manually enter a Static Subnet Mask address –then press
STARTING A SCAN TO PC (NETWORK)
1. Load a Document into the scanner
2. At scanner Display Panel –choose - setup your scan –then press
-
NOTE: If you encounter a problem - You may have to restart the Scanner and/or reboot PC –
so they can see each other –and try the Scan to PC once again !