Comelit GDX PAC-MGT-MD-IP-KT User manual
GDX IP Modem/Router
P/N: PAC-MGT-MD-IP-KT
Setup Guide Issue 1.0
Mar 2023
Power On
Power On
Power on Modem/Router
1. Connect the Network (RJ45) lead from the Modem/Router to the controller.
2. Apply power to the Modem/Router from the CONTROLLER.
3. Wait for Modem/Router LEDs to indicate a stable mobile connection.
4. Recycle power to the CONTROLLER.
5. Check the network port LEDs of the controller show traffic activity.
PAGE | 2
LED Information
LED Information
LED Statuses
Network type LEDs Signal strength LEDS
The table below shows the description of the LED combinations:
2G 3G 4G Description
Connected to 2G network
Connected to 3G network
Connected to 4G network
Connected to 2G network – but no IP address has been received
Connected to 3G network – but no IP address has been received
Connected to 4G network – but no IP address has been received
(Simultaneous blinking) – no SIM card or incorrect PIN
All LEDS
(LEDs blink in repeating sequence)– attempting to find network
Legend
LED is ON
LED is BLINKING / FLASHING
LED is OFF
PAGE | 3
SIM Replacement
SIM Replacement
Safety Information
The PAC-MGT-MD-IP-KT Modem/Router range must be used in compliance with all applicable
national and international laws and with any special restrictions regulating the utilisation of the
communication module in prescribed applications and environments.
SIMReplacement
1. Unscrew the two back panel hex bolts and remove the back panel.
2. Insert your SIM card into the SIM socket.
3. Attach the panel and tighten the hex bolts.
4. Connect the power adapter and plug into an AC mains outlet.
5. Attach the mobile antenna (max torque 0.4 N·m / 3.5 lbf·in).
6. Check for a confirmed connection in Housing Central Hardware page.
The "State" column will show 3 × green 'lights' for the Modem/Router.
PAGE | 4
Table of contents
