User manual
Telephone-Kit Comfort Contego
Works with most telephones which have
a modular connector to the handset
Components: 1) Switch box with 2) Cable (1) 3) Cable (2)
telephone cable
Getting started
1. Switch on your Contego transmitter and receiver by pressing the
On/Off-button for approx. 2 seconds.
2. Enter the menu of the Contego transmitter (T900).
Choose
Input - Microphone.
A small microphone shows in the down
left corner of the display.
3. Connect the induction loop to your Contego receiver (R900) and turn
the hearing aid to the T-position. If you do not use hearing aids, you
can use headphones instead.
Connect the Telephone-Kit to the Comfort Contego
1. Disconnect the handset
cable at the telephone.
2. I) Connect the switch box cable to the telephone.
II) Connect the handset cable to the switch box.
III) Connect the cable (1) to the switch box and the
line in of the Contego transmitter T900.
R800
Contego
9
CH:1
T900
3. I) Pick up the handset and check if you can
hear the dial tone (via your headphones
or the induction loop).
II) If you cannot hear the dial tone, try
cable(2); now you should be able to hear
the dial tone.
4. The telephone volume can be adjusted with
the arrows and at the Contego
transmitter (T900).
Make / Receive a call
Use the telephone as normal. You talk into
the handset.
The voice of your communication partner
is sent from the Contego transmitter T900
to your Contego receiver R900.
You hear with headphones or via the
induction loop with your hearing aid in
T-position.
You can adjust the volume of the call with
the volume control of your Contego receiver
(R900) during an ongoing call.
