Commercial LED CLF4-15P Series User manual

INSTALLATION INSTRUCTION MANUAL
LED FLOOD LIGHT, 100-277VAC
Rev ASep. 2018
SERIES:
CLF4-15PXYYZZ;CLF4-30PXYYZZ;CLF4-30PXYYZZ
Model number parameter list:
APPLICATION ITEMS
1. Suitable for use in the following locations:
•
Ambient Temp: -20~+40°C
•
Wet Locations
Note: Save these instructions for future reference.
2. Installation
Item
Model
Input Voltage
Power
Factor
Watt
Input
Current
Net
Weight
A
CLF4-15PXYYZZ
100-277VAC
≥0.9
15W
0.18A
0.42kg
B
CLF4-30PXYYZZ
100-277VAC
30W
0.35A
1.2kg
C
CLF4-50PXYYZZ
100-277VAC
50W
0.6A
1.6kg
CAUTION – RISK OF FIRE MIN 75 °C SUPPLY CONDUCTOR
•This product should be installed, inspected, and maintained by a qualified electrician only, in
accordance with all applicable electrical codes.
CAUTION – RISK OF SHOCK DISCONNECT POWER BEFORE SERVICING
•Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
To avoid explosion:
•Make sure the supply voltage is the same as the rated luminaire voltage.
•Do not install where the marked operating temperatures exceed the ignition temperature of
the hazardous atmosphere.
•Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•Keep lens tightly closed when in operation.
No serviceable parts.
B
C
A

Installation Steps:
Refer to the following diagram when you install the fixture.
1. Directly fix to mounting surface
1.Use expansion bolts to secure the fixture on mounting surface.
2. Keep enough length wires to ensure adjusting angle unhindered.
Connect wires into wiring terminal; white wire to “Neutral” terminal, black wire to “Live” terminal,
green wire to “Ground” terminal; and fix them by screws.
2. Mounting with a knuckle
Secure service wire or conduit to the wiring compartment cover with 1/2” connector ( not
provided ). Connect white fixture wire to white supply wire, black fixture wire to black supply wire.
Service ground should be attached to green ground screw rovided. Ground must be properly
attached to avoid the risk of electrical shock. Use wire nuts, crimp-on lugs, or other approved
devices to connect all wires, make sure connections are secure and that no loose wire strands are
sticking out of connectors, Secure wiring compartment cover to fixture. With black and white
connections inside the wiring compartment. Use UL and CUL Listed flexible steel waterproof conduit
in trade sizes 1/2 and UL and CUL Listed Water-proof outlet box cove.
After installation, please
Check whether the lighting fixture is firmly fixed.
Check whether wires are connected correctly.
At last, turn on the power, and check if the lighting fixture works well. If not, please turn off the
power and contact with local dealer.
CLF4-15PXYYZZ
CLF4-30PXYYZZ
CLF4-50PXYYZZ
Commercial LED
[email protected]
www.comm-led.com