Switch on or off the CIBS Neck Loop
How to switch on the CIBS Neck Loop:
Keep the On/Off button• 2pressed until you see the
Battery indicator light 7turn blue. At the same time you should
hear a signal via the T-Loop or via the headset connected to the
CIBS Neck Loop.
How to switch off the CIBS Neck Loop:
Keep the On/Off button• 2pressed until you see the
Battery indicator light 7turn red. At the same time you should hear
a signal via the T-Loop or via the headset connected to the
CIBS Neck Loop.
Pairing the unit
The units of CIBS AUDIO must be programmed to communicate
with each other. This is done by connecting them wirelessly.
Something we have called pairing.
NOTE: It is important that the CIBS Neck Loop and the Audiostreamer
are within a distance of 1 meter while pairing and that the
CIBS Neck Loop is fully charged.
Both units in the CIBS Audio (CIBS Neck Loop and Audiostreamer)
are ready-paired. If any difficulties arise, such as the pairing fades,
you can use the instructions below.
Switch on the CIBS Neck Loop (see page 8 for instructions).• Press and hold the pairing button• 5on the CIBS Neck Loop
until the Battery indicator light 7flashes alternately red and
blue. At the same time you should hear a double tone via the
T-loop of the headset on the CIBS Neck Loop.
Press and hold the pairing button• 13 on the Audiostreamer
until the communication light 11 on the Audiostreamer flashes
alternately red and blue.
When the CIBS Neck Loop and Audiostreamer are paired,• they will establish a sound connection between each other.
The communication light 11 on the Audiostreamer will
illuminate solid blue. It will do this every time it has a audio
connection with the CIBS Neck Loop.
If the pairing is unsuccessful, repeat this section.•
