Community Controls MONARCH 295SEPA2KC User manual

CONTENTS
1A- General information
1B- Technicalspecifications
1C- Main components
1 - TRANSMITTER OVERVIEW
2 - NUMBERING
3 - PROGRAMMING
4 - OPERATION
5 - BATTERY ACCESS
1B - Technical specifications
Operating frequency 295 MHz
Number of keys: 2
Battery : 2 x 3V lithium batteries CR2016
Battery life: 18 ÷ 24 months
Number combinations : 16,777,216
Protocol : AUTOkey compatible
Operating temperature: -20°F÷+131°F (-20°C÷+55°C)
Overall dimensions: 2.4”x1.4”x0.51” (61x36x13 mm)
Weight: 0.49 oz. (14 gr.)
1C - Main components
LED
Key
holder
ring
Light grey
push-buttons
Community
Controls®
Thank you for choosing a Community Controls® product .
Please read this manual carefully before using the product.
Made in Italy. Copyright © 2013 by Community Controls®.
6 - TROUBLESHOOTING
295SEPA2KC MONARCH
Dark grey
case
Fig. 2
1A- General information
TheCommunity Controls® Monarch 295SEPA2KC transmitter isa key
chain style 2 buttons mini transmitter operating at 295MHz.It has been
designed for use with programmable telephone entry, security, and
accesscontrol systems operating with a 295MHz frequency receiver.
The protocol is AUTOkey compatible and the code sent by the
transmitter includes a 24 bit security code which allows up to
16,777,216 codecombinations.
The Community Controls® 295R receiver which operates with this
transmitter has a Wiegand 33 bit and can operate any type of access
control system equipped with the same protocol. The CR 2016lithium
batteries of the transmitter have a shelf life of about 6 months. The
product fully complies with Part 15 of FCC Regulations and the
European Directives 99/5/CE, 89/336/CEE, 73/23/CEE.
Manual
with Patented®
ChargeGuard
Circuit

The warranty period of 295 transmitters is 24 months,
beginning from the manufacturing date of the transmitter . During this period, if the
product does operate correctly , due to a defective component, the product will be
repaired or replaced at the sole discretion of
The warranty does not extend to the transmitter case which can be damaged by
conditions outside the control of or to battery life.
Community Controls®
Community Controls®.
Community Controls®
WARRANTY
Community Controls® - Type : 295SEPA2KC
FCC ID : SU7295SEPA2KC
This device complies with FCC Rules
Operation is subject to the following twoconditions:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including
interference that may cause undesired operation.
Part. 15 of the
Notice
2 - NUMBERING
To access the battery open the case with a screwdriver acting on the slot between
the cover and the bottom and remove the bottom, as shown in fig. 3a and 3b.
Slide out the old batteries and replace them with the new ones [CR2016]
respecting the polarity, with the positive (+) side upward.
NOTE: Please dispose of the batteries properly according to local laws and
regulations. Test proper battery installation by verifyingthat the LED illuminates
whenthe button ispushed.
5 - BATTERY ACCESS
3 - PROGRAMMING
Each transmitter is manufactured and sold with a different factory- set serial
number .
The transmitter must be programmed into your system memory.
Your own installer or reseller will provide you the necessary instructions for your
system.
4 - OPERATION
A- Firmly depress the button until the small red LED illuminates.
B - After the LED has illuminated, release the button.
If the deviceyou are attempting to activate does not respond, repeat steps A and B
or consult section 7( Troubleshooting ) of this manual.
Fig. 3a
Fig. 3b
6 - BATTERY STATUS
Led GREEN Normal level ~6000 pulses [*] - Normal range
Led ORANGE Attention level Max 300 pulses - L ow range[*]
Led RED Low level Replace battery - Norange
Led color Battery level TX Status
The system does not receive the
transmitter signal.
The transmitter LED is ON
Check to verify the transmitter is
programmed into your system
PROBLEM SOLUTION
The operating range is reduced Replace the transmitter batteries
7 - TROUBLESHOOTING
[ *] : Dependson batteriestypeandoperatingconditions. Batterieslife calculated
with1-secpulses.
COMMUNITY CONTROLS®
2480 South 3850 West, Suite A
Salt Lake City, UT 84120
[phone] - [phone] Fax
www.communitycontrols.com
Any changes or modifications not expressly approved by Community Controls®
could void the user’s authority to operate this equipment.