Conair BE84 User manual

IMPORTANT SAFETY
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE TAKEN,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
BEFORE USING APPLIANCE.
KEEP AWAY FROM WATER
DANGER –TO REDUCE THE RISK
OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS
APPLIANCE FROM THE ELECTRICAL OUTLET
BEFORE CLEANING.
WARNING–TO REDUCE THE RISK
OF BURNS, ELECTROCUTION, FIRE, OR INjURY TO
PERSONS:
1. Unplug from outlet before putting on or taking
off parts.
2. This mirror should not be used by or near children
or individuals with certain disabilities.
3. Use this mirror only for its intended use as
described in these instructions. Do not use
attachments not recommended by the manufacturer.
4. Never operate this mirror if it has a damaged cord
or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water. Return
the mirror to a service center for examination and
repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert an object into any opening.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products are
being used or where oxygen is being administered.
9. To disconnect, be sure mirror is in the off position,
then remove plug from outlet.
10. Do not leave appliance unattended when it is
plugged in.
11. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause fire.
12. Do not use on a soft surface such as a bed, where
openings may be blocked.
13. Touch knob on mirror base until light shuts off.
Allow unit to cool and unplug cord before replacing
light bulbs.
14. Do not place or store appliance where it can fall
or be pulled into a tub or sink.
15. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
16. To protect against electrical hazards, do not use
while bathing or in the shower.
17. Never use while sleeping.
18. Do not use a bulb greater than 13 watts.
Use on any 120 volt 60 hertz AC electric outlet
(ordinary house current). Do not use it on any other
electrical outlet.
FOR HOUSEHOLD USE ONLY
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a
polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
CAUTION: BE SURE DIRECT SUNLIGHT DOES
NOT STRIKE MIRROR WHEN LEFT UNATTENDED;
REFLECTED SUNLIGHT CAN CAUSE FIRE.
1. Your lighted makeup mirror will rotate 350° so that
you can use either the normal, flat mirror or the 8x
magnifying mirror located on the opposite side.
2. Plug into any standard 120
volt wall outlet. The mirror light
is activated by touch. Touch the
base to turn light on or off.
3. After use, always touch the
knob on the base to turn the
mirror to the OFF position
and unplug.
4. The beauty and design of this mirror complement
any decor. Therefore, you may wish to leave the
mirror displayed. However, if you choose to store
the mirror, see section about storage for detailed
information.
Special Feature
This lighted makeup mirror uses a fluorescent
bulb. The bulb lasts up to 10,000 hours and does
not require replacement. In the unlikely event
that the bulb does need replacement, follow the
instructions below.
REPLACING FLUORESCENT TUBE LAMP
CAUTION: Turn off power and unplug mirror. Allow
to cool at least three minutes before replacing
fluorescent tube lamp. Replace tube lamp only
with tube lamp of same wattage rating. Remove
tube lamp with care to avoid breakage.
REPLACING FLUORESCENT TUBE LAMP
1. This mirror uses a 13W
maximum 120V type plug-in
fluorescent tube lamp.
2. Remove screws from left and
right sides of mirror. (See Fig. 1.)
3. Carefully lift off the removable housing from the
half that is affixed to the stand.
4. A cable tie is used to
protect the fluorescent tube
lamp during transportation. To
replace the fluorescent tube
lamp, you must first cut the
cable tie. While holding the
socket, pull the fluorescent
tube lamp out of the socket
with care to avoid breakage.
(See Fig. 2.) Align the metal
pins on the fluorescent tube
lamp with the holes in the
socket and push gently to
secure. (See Fig. 3.) After
the fluorescent tube lamp is
replaced, there is no need to
replace the cable tie.
5. Carefully replace the removable half after locating
and aligning the screw holes to the fixed half.
6. Insert screws into screw holes and tighten.
Fig. 1
Fig. 2
Fig. 3

LIMITED ONE YEAR WARRANTY
Conair will repair or replace (at our option) your unit free
of charge for 12 months from the date of purchase if the
appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective
product to the service center listed below, together with
your purchase receipt and $3.00 for postage and handling.
California residents need only provide proof of purchase and
should call 1-800-366-0937 for shipping instructions. In the
absence of a purchase receipt, the warranty period shall be
12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE 12-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY. Some states
do not allow limitations on how long an implied warranty
lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER. Some states do not
allow the exclusion or limitation of special, incidental, or
consequential damages, so the above limitation may not
apply to you.
This warranty gives you specific legal rights, and you may
also have other rights, which vary from state to state.
©2007 Conair Corporation
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
Model BE84
KEEP AWAY FROM WATER
Everybody knows that electricity and water are a
dangerous combination. But did you know that an
electrical appliance is still electrically live even if
the switch is off? If the plug is in, the power is on.
So when you are not using your appliances, keep
them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
WARNING:
IF YOU THINK THE
POWER IS OFF
WHEN THE SWITCH
IS OFF,
YOU’RE WRONG.
07NP201 IB-7765
Model BE84
®
Use and Care Guide
For your safety and continued enjoyment
of this product, always read the instruction
book carefully before using.
Natural Daylight
Mirror
Natural Daylight for Natural Looks
™
Storage
Disconnect from electrical outlet. BE SURE DIRECT
SUNLIGHT DOES NOT STRIKE MIRROR WHEN LEFT
UNATTENDED. Allow to cool to room temperature
before storing. Place in cool, dry area out of reach of
children, where mirror will not be damaged.
Handle cord carefully to extend life of mirror; do
not jerk or strain at plug connections, or wrap cord
around mirror for storage. This could cause damage
to the cord or a short circuit. To store mirror, coil cord
loosely.
Maintenance
Your lighted mirror is designed for household use
and is virtually maintenance-free. No lubrication
is needed.
If cleaning becomes necessary, disconnect the
appliance from the power source, allow to cool and
wipe exterior with a damp cloth. Clean mirror surfaces
with a glass cleaner. Do not light until you are certain
mirror is completely dry. If any abnormal condition
occurs, unplug the lighted mirror, allow it to cool, and
return it to an authorized service center for repair.
Handle cord carefully to prolong its life; do not jerk or
strain at plug connections, or wrap cord around mir-
ror for storage. This could cause damage to the cord
or a short circuit. To store mirror, coil cord loosely.