CONCORD Elevation User manual

The Responsible Solution
Elevations Assembly
Instructions

2
ITEM DESCRI TION QTY
9CROSS BRACE
BOLTS (O TIONAL) 12
1WORKSURFACE 1
2CONTROL BOX 1
3HANDSET,
CONTROL BOX AND
-CLI FASTENERS
9
4CONTROL BOX
OWER CORD 1
5LEG ASSEMBLY
MOUNTING
FASTENERS
16
6LEG ASSEMBLY 2
7HANDSET 1
8CROSS BRACE
FASTENERS
(O TIONAL)
2

3
STE 1: ASSEMBLE FRAME Set worksurface upside down on a flat stable surface. Locate 2 leg assemblies and cross braces (if included)
on work surface. If your table has only one cross brace, position the cross brace to the back of the worksurface. Insert cross brace
fasteners hand tight (3 locations on each cross brace end, see FIGURE "A"). If your table does not require a cross brace proceed to STE 2.
STE 2: ASSEMBLE TABLE Locate each leg assembly on the work surface per drawing template.(see Figure" B"). Locate each leg assembly on the
front to back center line of the work surface (see FIGURE "C"). If your table has a cross brace locate the center line of the cross brace on the right
to left center line of the work surface (see FIGURE "C"). roceed to insert the leg assembly mounting fasteners, 8 per leg (FIGURE "B").Once the
legs are fastened to the worksurface completely tighten the cross brace fasteners.

4
STE 3: ASSEMBLE ELECTRONICS Locate the handset and control box on the work surface as shown in Figure "E", Figure "F" and Figure
"G".Once the control box and handset are located in their approximate position, insert the corresponding mounting fasteners.

5
STE 4: ELECTRICAL CONNECTIONS DO NOT LUG IN OWER CORD INTO THE ELECTRICAL OUTLET UNTIL LEG ASSEMBLIES AND HAND-
SET ARE CONNECTED TO CONTROL BOX. Connect handset cord and leg assembly cords, to the control box. See FIGURE "I".Use wire -clip
fasteners to secure wires to tabletop. Once connections are made, upright the table and plug in the power cord.
*WARNING: Do not swap the control box or legs with other tables, as this may cause the legs to become out of sync and cause damage.
STE 5: LEVELING TABLE Adjust glides until work surface is level. (FIGURE "J")
CROSS BRACE FASTENERS (OPTIONAL)

6
STE 6: FIRST TIME INITIALIZING THE LEGS.Depress and hold the down button. The table will move slightly down and then slightly back up.
Release the down button. The legs are now initialized and ready for use.
ress the memory key.
The display will read S-.
ress and hold the desktop down key (down arrow) for
approximately 5 seconds.
The display will start flashing.
Adjust the height display by pressing the down and up
arrows
ress the memory key.
STE 7: CHANGING THE DIS LAY HEIGHT. If the display height does not match the actual height of the table top, follow these steps.

7

The Responsible Solution
www.concordproducts.com
1.800.220.5043
COMMITTED TO:
the environment
responsible manufacturing
minimal waste
® Trademarks of Concord Products Compan , Inc. INSTAL-ELEVATION-0121