Connect SmartHome CSH-STP5NEO User manual

Manual
Smart Neon Light
(CSH-STP5NEO / LSH-STP5NEO)
1GET THE APP
QR Codes for
Downloading Apps
2REGISTER OR
LOGIN TO APP
TAP
HERE
3RECOMMENDED APP SETTINGS
LOGIN
existing
account
REGISTER
no
account

5CONNECTING LIGHT TO APP
4POWERING
LIGHT
PRESS
6 SEC
Press and HOLD 6 seconds
untill Neon Strip Light
starts flashing quickly
TIP
If device
not found
please check
Only 2.4G Wi-Fi
networks are supported

7LIGHT
SETTINGS
8
REMOVING
LIGHT
SCROLL
DOWN
6USING THE LIGHT
COLOUR WHITE
Lights react to sounds
from microphone of
connected device
e.g. smartphone
MUSIC MODE
COLOUR

9INSTALLATION IDEAS
For more
helpful guides
visit us at
LASER
www.youtube.com/LasercoAu
CONNECT
www.youtube.com/channel/UCCYzBiADapJN55Zzp3yfvLQ
WARRANTY
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have
the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
www.laserco.com.au www.connectsmarthome.com.au
TIP
Saddle Clips work well
for mounting
The device is not connecting
to the APP:
• Check your Wifi username and password are
correct and you are only using 2.4Ghz Wifi
connections as the 5Ghz band is not supported.
The light is not blinking / entering
pairing mode:
• Press and hold the pairing button for a longer
period of time.
The light is blinking slowly
and will not pair:
• The light might be in AP pairing mode.
You can pair the light in AP Mode by
switching from EZ Mode to AP Mode
on the “Reset the Device first” screen
in the APP.
TROUBLESHOOTING
• Try waiting a few seconds and holding the pairing
button again.
• Stop pressing the pairing button and
press and hold again to put the light
into the fast blinking pairing mode.