Chapter 2: Setting up your device
Before starting to use your new DOTS.bike make sure to recharge the
Power-Light and the Tracker for at least 3 hours.
For subsequent uses it will be sucient to recharge only the Power-Light
and insert it correctly inside the Drawer [see “Recharging your DOTS.bike”
pag 16].
For the safety of your bike and DOTS.bike, we recommend that you add the
Anti-theft saddle bolt & nut and set a new password for the Combination
Lock. (0-0-0 is the default combination).
Note: do not forget the code you set, as you need it to unlock the tool and
change the code. Use the App to store your code whenever you set a new
code [see “Combination Lock Code Memo” pag 30].
Setting a code for the Combination Lock
1. Make sure the code is set to default combination (0-0-0)
2. Extract the Drawer from the DOTS.bike by sliding it with your ngers
3. Use the Combination Lock Tool provided to press and hold the two
holes on the lock inside the housing near the Combination Lock and
turn the dial
4. Set a new code. Release the Combination Lock Tool. You have now set
the new code.
3
2
4
1
8
0
00
